User manual MAKITA GT120

[. . . ] Failure to observe these precautions can lead to severe injury or death!26 For European countries only EC Declaration of Conformity The undersigned, Tamiro Kishima and Rainer Bergfeld, as authorized by Dolmar GmbH, declare that the DOLMAR machine(s): Designation of Machine: Power Cutter Model No. / Type: PC-7612V , PC-7614V Specifications: see “Technical data” table. Are of series production and Conforms to the following European Directives: 2000/14/EC, 2006/42/EC And are manufactured in accordance with the following standards or standardised documents: EN ISO 19432 The technical documentation is on file at: Dolmar GmbH, Jenfelder Straße 38, Abteilung FZ, D-22045 Hamburg The conformity assessment procedure required by Directive 2000/14/EC was in Accordance with annex VIII. [. . . ] Perform only the maintenance and repair works described in the instruction manual. All other work must be carried out by DOLMAR Service (28). use only original DOLMAR spares and accessories. The use of non-DOLMAR spares, accessories, or cutting discs increases the risk of accident. We cannot accept any responsibility for accidents or damage occurring in association with the use of cutting discs or accessories other than original DOLMAR. 27 SERVICE 28 First aid (29) Make sure that a first aid kit is always immediately available close by. Immediately replace any items used from the first aid box. use only original DOLMAR spares and accessories. NOTE: Individuals with poor circulation who are exposed to excessive vibration may experience injury to blood vessels or the nervous system. Vibration may cause the following symptoms to occur in the fingers, hands or wrists: “Falling asleep” (numbness), tingling, pain, stabbing sensation, alteration of skin colour or of the skin. If any of these symptoms occur, see a physician!  Mount a diamond cutting disc/cut-off abrasive disc (4) on the arbor (5). NOTE:  Tighten the hex bolt firmly (25 - 31 Nm), as otherwise the cutting wheel may slip during cutting. 13 Tightening the V-belt / Checking V-belt tension IMPORTANT: Exact V-belt tension is essential for maximum cutting performance with minimum fuel consumption. Improper V-belt tension will result in premature wear to the V-belt and V-belt wheel or damage to the clutch bearing. Nut (9) must be loosened before tightening the V-belt or checking the tension. To increase the belt tension, turn the tension screw (10) to the right (clockwise) with the combination wrench included with the Power Cutter. The belt tension is correctly adjusted when the nut (11) is located as shown in the figure compared to the position of the mark (12). IMPORTANT: • After tightening/inspection, make certain to tighten the hex. 11 9 12 10 Before operating 1. Checking/replenishing engine oil • With the engine in a cool state, check/replenish engine oil in the following way. € Position engine on a flat level, and check to see whether oil is within the range of MAX and MIN of the oil tank. [. . . ] (Recommended replacement: 1 month) Set throttle lever from medium speed to high speed, and pull starter handle until engine starts. Once engine starts, cutting disc starts rotating. If engine will not start still, remove spark plug, make electrode dry, and reassemble them as they originally are. Make request for inspection and maintenance. [. . . ]