User manual MAKITA HM1202

[. . . ] Save all warnings and instructions for future reference. Hold power tool by insulated gripping surfaces, when performing an operation where the cutting accessory may contact hidden wiring or its own cord. Cutting accessory contacting a "live" wire may make exposed metal parts of the power tool "live" and could give the operator an electric shock. Wear a hard hat (safety helmet), safety glasses and/or face shield. [. . . ] Pull the tool holder cover down a couple of times. Turn the bit and push it in until it engages. After installing, always make sure that the bit is securely held in place by trying to pull it out. To remove the bit, pull the tool holder cover down all the way and pull the bit out. 9) The bit can be secured at 12 different angles. To change the bit angle, slide the change ring forward, then turn the change ring to change the bit angle. The change ring cannot turn when the bit is not installed on the tool. Before plugging in the tool, always check to see that the tool is switched off. To start the tool, push the switch lever on the left side of the tool. For HM1202C only The blows per minute can be adjusted just by turning the adjusting dial. This can be done even while the tool is running. the dial is marked 1 (lowest speed) to 6 (full speed). Refer to the table below for the relationship between the number settings on the adjusting dial and the blows per minute. Turn the tool on and apply slight pressure on the tool so that the tool will not bounce around, uncontrolled. Pressing very hard on the tool will not increase the efficiency. The speed adjusting dial can be turned only as far as 6 and back to 1. Do not force it past 6 or 1, or the speed adjusting function may no longer work. Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. For HM1202C only The green power-ON indicator lamp lights up when the tool is switched ON. If the indicator lamp is lit but the tool does not start, the carbon brushes may be worn out, or the electric circuit or the motor may be defective. If the indicator lamp does not light up and the tool does not start, the ON/OFF switch or the mains cord may be defective. The red service indicator lamp lights up when the carbon brushes are nearly worn out to indicate that the tool needs servicing. [. . . ] â· Be sure to identify safety measures to protect the operator that are based on an estimation of exposure in the actual conditions of use (taking account of all parts of the operating cycle such as the times when the tool is switched off and when it is running idle in addition to the trigger time). We Makita Corporation as the responsible manufacturer declare that the following Makita machine(s): Designation of Machine: Demolition Hammer Model No. / Type: HM1202 , HM1202C Specifications: see "SPECIFICATIONS" table. Are of series production and Conforms to the following European Directives: 2000/14/EC, 2006/42/EC And are manufactured in accordance with the following standards or standardised documents: EN60745 The technical documentation is kept by our authorized representative in Europe who is: Makita International Europe Ltd. [. . . ]