User manual MAKITA HM1303B

[. . . ] Note: Specifications may differ from country to country. Power supply The tool should be connected only to a power supply of the same voltage as indicated on the nameplate, and can be operated on single-phase AC/DC supply. They are double-insulated in accordance with European Standard and can, therefore, also be used from sockets without earth wire. [. . . ] Do not touch the bit or parts close to the bit immediately after operation; they may be extremely hot and could burn your skin. Important: Always be sure that the tool is switched off and unplugged before installing or removing the bit. This tool accepts bits either with or without a collar on its shank. To securely retain the bit, return the tool retainer to its original position. CAUTION: Always assure that the bit is securely retained by attempting to pull the bit out of the tool holder after completing the above procedure. With the notched portion of the bit facing the tool retainer shaft, insert the bit into the tool holder as far as it will go. Then pivot the tool retainer further downward toward the barrel to securely retain the bit. Always assure that the bit is securely retained by attempting to pull the bit out of the tool holder after completing the above procedure. The bit without a collar cannot be retained by the method shown in Fig. Turn the tool on and apply slight pressure on the tool so that the tool will not bounce around, uncontrolled. Pressing very hard on the tool will not increase the efficiency. CAUTION: Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. Whenever carbon brushes must be replaced, they cut out the tool automatically. When this occurs, remove the holder cap plates and then replace both carbon brushes at the same time. This tool requires no hourly or daily lubrication because it has a grease-packed lubrication system. Lubricate the tool every time the carbon brushes are replaced. Remove the plate 50 using a screwdriver, then replenish with fresh grease (15 g). use only Makita genuine grease (optional accessory). [. . . ] For continuous operation, pull the trigger and then slide down the lock button. To stop the tool from the locked position, pull the trigger fully, then release it. Kontrollera alltid att att strömställaren fungerar felfritt och återgår till avläget "OFF" när den släpps innan stickproppen till maskinen sätts i. [. . . ]