User manual MAKITA HM1307CB

[. . . ] Model Blows per minute Overall length Net weight · Note: Specifications may differ from country to country. Due to our continuing programme of research and development, the specifications herein are subject to change without notice. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. [. . . ] Exposure to noise can cause hearing loss. Use auxiliary handle(s), if supplied with the tool. loss of control can cause personal injury. Hold power tool by insulated gripping surfaces, when performing an operation where the cutting accessory may contact hidden wiring or its own cord. Cutting accessory contacting a "live" wire may make exposed metal parts of the power tool "live" and could give the operator an electric shock. Wear a hard hat (safety helmet), safety glasses and/or face shield. Ordinary eye or sun glasses are NOT safety glasses. it is also highly recommended that you wear a dust mask and thickly padded gloves. Be sure the bit is secured in place before operation. under normal operation , the tool is designed to produce vibration. The screws can come loose easily, causing a breakdown or accident. check tightness of screws carefully before operation. In cold weather or when the tool has not been used for a long time, let the tool warm up for a while by operating it under no load. Be sure no one is below when using the tool in high locations. Do not point the tool at any one in the area when operating. The bit could fly out and injure someone seriously. Do not touch the bit or parts close to the bit immediately after operation; they may be extremely hot and could burn your skin. do not operate the tool at no-load unnecessarily. Some material contains chemicals which may be toxic. Take caution to prevent dust inhalation and skin contact. CAUTION: Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to safety rules for the subject product. [. . . ] Always assure that the bit is securely retained by attempting to pull the bit out of the tool holder after completing the above procedure. ⷠThe bit without a collar cannot be retained by the method shown in Fig. Always use the side grip (auxiliary handle) and firmly hold the tool by both side grip and switch handle during 6 Then replenish with fresh grease (60g). use only Makita genuine hammer grease (optional accessory). [. . . ]