User manual MAKITA HP2042

[. . . ] Important: Always be sure that the tool is switched off and unplugged before installing or removing the side grip, bit or other accessories. DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to hammer drill safety rules. If you use this power tool unsafely or incorrectly, you can suffer serious personal injury. Exposure to noise can cause hearing loss. [. . . ] If you operate the tool with the button positioned half-way between the mode symbols, the tool may be damaged. NOTE: The depth gauge cannot be used at the position where the depth gauge strikes against the gear housing. , depress the action mode change button from the side with g symbol to use "rotation with hammering" action. Be sure to use a tungsten-cabide tipped bit. Do not apply more pressure when the hole becomes clogged with chips or particles. Instead, run the tool at an idle, then remove the bit partially from the hole. By repeating this several times, the hole will be cleaned out. After drilling the hole, use the blow-out bulb to clean the dust out of the hole. 9) Drillng operation When drilling in wood, metal or plastic materials, depress the action mode change button from the side with f symbol to use "rotation only" action. Drilling in wood When drilling in wood, best results are obtained with wood drills equipped with a guide screw. The guide screw makes drilling easier by pulling the bit into the workpiece. Drilling in metal To prevent the bit from slipping when starting a hole, make an indentation with a centerpunch and hammer at the point to be drilled. place the point of the bit in the indentation and start drilling. Use a cutting lubricant when drilling metals. The exceptions are iron and brass which should be drilled dry. In fact, this excessive pressure will only serve to damage the tip of your bit, decrease the tool performance and shorten the service life of the tool. Hold the tool firmly and exert care when the bit begins to break through the workpiece. A stuck bit can be removed simply by setting the reversing switch to reverse rotation in order to back out. However, the tool may back out abruptly if you do not hold it firmly. Always secure small workpieces in a vise or similar hold-down device. CAUTION: Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. for HP2040 and HP2041 To start the tool , simply pull the trigger. [. . . ] Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Makita service center. Carrying case Depth gauge Chuck key Blow-out bulb Hole saw 79 mm and 95 mm Safety goggle Tungsten-carbide tipped bit "M" stands for max. Periodically clean the vent holes to prevent them from being clogged with dust, dirt or the like. [. . . ]