User manual MAKITA HP330D

[. . . ] Sleeve Blow-out bulb Holster holder Waist belt SPECIFICATIONS Model Concrete Steel Capacities Wood Wood screw Machine screw No load speed (min-1) Blows per minute (min ) Overall length Net weight Rated voltage -1 HP330D 8 mm 10 mm 21 mm 5. 8 V High (2) Low (1) High (2) Low (1) • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. € Specifications and battery cartridge may differ from country to country. € Weight, with battery cartridge, according to EPTA-Procedure 01/2003 Intended use ENE079-1 The tool is intended for impact drilling in brick, concrete and stone. [. . . ] FUNCTIONAL DESCRIPTION CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool. 3) CAUTION: • Do not look in the light or see the source of the light directly. Pull the switch trigger to turn on the light. The lamp keeps on lighting while the switch trigger is being pulled. The lamp turns off just after releasing the trigger. NOTE: • Use a dry cloth to wipe the dirt off the lens of lamp. Be careful not to scratch the lens of lamp, or it may lower the illumination. installing or removing battery cartridge (Fig. 1) CAUTION: • Always switch off the tool before installing or removing of the battery cartridge. When the reversing switch lever is in the neutral position, the switch trigger cannot be pulled. CAUTION: • Always check the direction of rotation before operation. € Use the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool. € When not operating the tool, always set the reversing switch lever to the neutral position. NOTE: • The fastening torque can be adjusted only when the arrow points toward the mark on the ring. ASSEMBLY CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. installing or removing driver bit or drill bit (Fig. 8) Turn the sleeve counterclockwise to open the chuck jaws. Place the bit in the chuck as far as it will go. Turn the sleeve clockwise to tighten the chuck. To remove the bit, turn the sleeve counterclockwise. Be sure that the speed change lever is set to the correct position before operation. [. . . ] € Do not pull the switch trigger repeatedly when the motor is locked. Drilling in wood When drilling in wood, the best results are obtained with wood drills equipped with a guide screw. The guide screw makes drilling easier by pulling the bit into the workpiece. Drilling in metal To prevent the bit from slipping when starting to make a hole, make an indentation with a center-punch and hammer at the point to be drilled. [. . . ]