User manual MAKITA HR4002 ANNEXE 893

[. . . ] / Type: HR4002 are of series production and Conforms to the following European Directives: 98/37/EC until 28th December 2009 and then with 3 2006/42/EC from 29th December 2009 And are manufactured in accordance with the following standards or standardised documents: EN60745 The technical documentation is kept by our authorised representative in Europe who is: Makita International Europe Ltd, Michigan, Drive, Tongwell, Milton Keynes, MK15 8JD, England Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. In cold weather or when the tool has not been used for a long time, let the tool warm up for a while by operating it under no load. Be sure no one is below when using the tool in high locations. Do not point the tool at any one in the area when operating. [. . . ] CAUTION: Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. 1 CAUTION: Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. Use a bull point, cold chisel, scaling chisel, etc. CAUTION: Do not rotate the change lever when the tool is running under load. To avoid rapid wear on the mode change mechanism, be sure that the change lever is always positively located in one of the two or three action mode positions. Coat the bit shank head beforehand with a small amount of bit grease (about 0. This chuck lubrication assures smooth action and longer service life. Turn the bit and push it in until it engages. Pull the chuck cover down a couple of times. Turn the bit and push it in until it engages. After installing, always make sure that the bit is securely held in place by trying to pull it out. To remove the bit, pull the chuck cover down all the way and pull the bit out. The torque limiter will actuate when a certain torque level is reached. CAUTION: As soon as the torque limiter actuates, switch off the tool immediately. This will help prevent premature wear of the tool. 10 The bit can be secured at 12 different angles. Then make sure that the bit is securely held in place by turning it slightly. CAUTION: Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. Use the side handle only when chipping, scaling or demolishing. Do not use it when drilling in concrete, masonry, etc. The tool cannot be held properly with this side handle when drilling. The side handle can be swung 360° on the vertical and secured at any desired position. [. . . ] Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. 14 After drilling the hole, use the blow-out bulb to clean the dust out of the hole. Turn the tool on and apply slight pressure on the tool so that the tool will not bounce around, uncontrolled. [. . . ]