User manual MAKITA HS7101

[. . . ] Cutting depth at 45° at 50° No load speed (min–1) Overall length Net weight Safety class • Due to our continuing program of research and development, the specifications herein are subject to change without notice. €¢ Specifications may differ from country to country. DANGER: Keep hands away from cutting area and the blade. 0 kg GEB013-6 CIRCULAR SAW SAFETY WARNINGS Cutting procedures 1. [. . . ] Do not attempt to remove cut material when blade is moving. Wait until blade stops before grasping cut material. Inspect for and remove all nails from lumber before cutting. Place the wider portion of the saw base on that part of the workpiece which is solidly supported, not on the section that will fall off when the cut is made. A illustrates the RIGHT way to cut off the end of a board, and Fig. If the workpiece is short or small, clamp it down. Before setting the tool down after completing a cut, be sure that the lower guard has closed and the blade has come to a complete stop. Never attempt to saw with the circular saw held upside down in a vise. This is extremely dangerous and can lead to serious accidents. Some material contains chemicals which may be toxic. Take caution to prevent dust inhalation and skin contact. Do not stop the blades by lateral pressure on the saw blade. Always use blades recommended in this manual. Gum and wood pitch hardened on blades slows saw and increases potential for kickback. Keep blade clean by first removing it from tool, then cleaning it with gum and pitch remover, hot water or kerosene. Wear a dust mask and hearing protection when use the tool. WARNING: DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to safety rules for the subject product. MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. NOTE: • Use a dry cloth to wipe the dirt off the lens of lamp. Be careful not to scratch the lens of lamp, or it may lower the illumination. €¢ Do not use gasoline, thinner or the like to clean the lens of lamp. Using such substances will damage the lens. [. . . ] Then turn the tool on and wait until the blade attains full speed. Now simply move the tool forward over the workpiece surface, keeping it flat and advancing smoothly until the sawing is completed. To get clean cuts, keep your sawing line straight and your speed of advance uniform. If the cut fails to properly follow your intended cut line, do not attempt to turn or force the tool back to the cut line. [. . . ]