Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual MAKITA HW110. We hope that this MAKITA HW110 user guide will be useful to you.
Lastmanuals help download the user guide MAKITA HW110.
Detailed instructions for use are in the User's Guide.
[. . . ] The safety valve is also a pressure limiting valve. When the gun trigger is released, the valve opens and the water recirculates through the pump inlet. All installation and assembly operations must be performed with the appliance disconnected from the mains power supply. [. . . ] When using detergent, the adjustable nozzle must be set on " " (on models with this feature). Fill the tank with highly degradable detergent. Dissolve dirt by applying the detergent mixed with water to the surface while still dry. When dealing with vertical surfaces work from the bottom upwards. Leave the detergent to act for 1-2 minutes but do not allow the surface to dry. Starting from the bottom, use the high pressure jet at a minimum distance of 30 cm. Do not allow the rinse water to run onto unwashed surfaces. Set the adjustable nozzle on " " to deliver detergent at the correct pressure (on models with this feature). The regulator (G) is used to adjust the working pressure. The pressure is shown on the pressure gauge (where fitted). Adjusting the pressure (on models with this feature) Set the starter switch on (ON/1) to: a) start the motor (in models without TSS device); b) set the motor ready to start (in models with TSS device). If there is a pilot light on the starter device, it should light up. If the "low/high" settings are available, use them as follows: Low : low pressure washing High : high pressure washing Set the starter device switch on (OFF/0) to shut down the appliance. If there is a pilot light on the starter device, it should go out. [. . . ] Treat the appliance with non-corrosive, non-toxic antifreeze before storing it away for winter. Possible causes Nozzle worn Water filter fouled Water supply pressure low Air being sucked into system Air in pump Adjustable nozzle not positioned correctly Water intake from external tank Intake water too hot Nozzle clogged Insufficient power supply 5) Turn on water supply tap fully Check tightness of hose fittings Switch off the appliance and keep depressing and releasing the gun trigger until the water comes out in a steady flow. 5) Check that the voltage of the mains power supply line is the same as that on the plate (fig. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE MAKITA HW110
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual MAKITA HW110 will begin.
