User manual MAKITA JV100D

[. . . ] Cutting capacities Mild steel Aluminium Overall length Net weight Rated voltage • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. €¢ Specifications and battery cartridge may differ from country to country. €¢ Weight, with battery cartridge, according to EPTA-Procedure 01/2003 ENE019-1 JV100D 18 mm 0 – 2, 400 B type 65 mm 2 mm 4 mm 231 mm 1. Use clamps or another practical way to secure and support the workpiece to a stable platform. [. . . ] Large orbit cut- For fast cutting in wood ting action and plywood. FUNCTIONAL DESCRIPTION CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool. 3) CAUTION: • Before installing the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the “OFF” position when released. €¢ When not operating the tool, depress the lock-off button from A side to lock the switch trigger in the OFF position. To prevent the switch trigger from accidentally pulled, the lock-off button is provided. To start the tool, depress the lock-off button from B side and pull the switch trigger. Tool speed is increased by increasing pressure on the switch trigger. After use, always press in the lock-off button from A side. OPERATION CAUTION: • Always hold the base flush with the workpiece. Failure to do so may cause blade breakage, resulting in a serious injury. €¢ Advance the tool very slowly when cutting curves or scrolling. Forcing the tool may cause a slanted cutting surface and blade breakage. Turn the tool on without the blade making any contact and wait until the blade attains full speed. Then rest the tool base flat on the workpiece and gently move the tool forward along the previously marked cutting line. 9, 10 & 11) CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before tilting the base. €¢ Raise the dust cover all the way before making bevel cuts. With the base tilted, you can make bevel cuts at any angle between 0° and 45° (left or right). Loosen the bolt on the back of the base with the hex wrench. Move the tool base so that the bolt is positioned in the center of the cross-shaped slot in the base. Tilt the base until the desired bevel angle is obtained. Then tighten the bolt to secure the base. ASSEMBLY CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. [. . . ] Insert the hose of the vacuum cleaner into the hole at the rear of the tool. NOTE: • Dust extraction cannot be performed when making bevel cuts. OPTIONAL ACCESSORIES CAUTION: • These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. [. . . ]