User manual MAKITA KP0810

[. . . ] WARNING: For your personal safety, READ and UNDERSTAND before using. Model Planing width Planing depth Shiplapping depth No load speed (RPM) Overall length Net weight · Note: Specifications may differ from country to country. Due to our continuing programme of research and development, the specifications herein are subject to change without notice. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. [. . . ] Make sure the blade is not contacting the workpiece before the switch is turned on. Wait until the blade attains full speed before cutting. Always switch off and wait for the blades to come to a complete stop before any adjusting. Never stick your finger into the chip chute. Always change both blades or covers on the drum, otherwise the resulting imbalance will cause vibration and shorten tool life. Use only Makita blades specified in this manual. Always use the correct dust mask/respirator for the material and application you are working with. MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to planer safety rules. If you use this tool unsafely or incorrectly, you can suffer serious personal injury. Wait for the cutter to stop before setting the tool down. An exposed cutter may engage the surface leading to possible loss of control and serious injury. Use clamps or another practical way to secure and support the workpiece to a stable platform. CAUTION: Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. After a cutting operation, raise the back side of the tool and a foot comes under the level of the rear base. CAUTION: Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. A loose installation bolt can be dangerous. Always check to see they are tightened securely. Use gloves or rags to protect your fingers or hands when removing or installing the blades. Remove the existing blade, if the tool has been in use, carefully clean the drum surfaces and the drum cover. To remove the blades on the drum, unscrew the three installation bolts with the socket wrench. The drum cover comes off together with the blades. [. . . ] The speed and depth of cut determine the kind of finish. The power planer keeps cutting at a speed that will not result in jamming by chips. For rough cutting, the depth of cut can be increased, while for a good finish you should reduce the depth of cut and advance the tool more slowly. When you wish to perform clean planing operation, connect a Makita vacuum cleaner to your tool. [. . . ]