User manual MAKITA LC01

[. . . ] Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes. Read this instruction manual and the charger instruction manual carefully before use. Do not pick up the following materials: - Hot materials such as lit cigarettes or spark/metal dust generated by grinding/cutting metal - Flammable materials such as gasoline, thinner, benzine, kerosene or paint - Explosive materials like nitroglycerin - Ignitible materials such as Aluminum, zinc, magnesium, titanium, phosphorus or celluloid - Wet dirt, water, oil or the like - Hard pieces with sharp edges, such as wood chips, metals, stones, glasses, nails, pins or razors - Powder to clot such as cement or tonor - Conductive dust such as metal or carbon - Fine particle like concrete dust Such action may cause fire, injury and/or property damage. [. . . ] Now point suction inlet downwards, turn capsule in direction of arrow in diagram, and disconnect capsule slowly and straight. nOTE: · Dust may spill out when capsule is opened, so be sure to set a garbage bag beneath capsule. CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. Remove accumulated dust from inside of capsule and off of prefilter. CAUTION: Empty the cleaner before it becomes too full, or the suction force weakens. Be sure to empty out the dust inside the cleaner itself. Twist prefilter in direction of arrow to unfasten securing lip from cleaner unit and then pull off prefilter. In order to drop dust sticking on the filter in the capsule, tap the capsule 4 or 5 times with your hand. Align projection on capsule with projection on handle and then firmly twist capsule in direction of arrow until it is secured. Put on filter until it is fully in position on the cleaner unit. nOTE: · Make sure filter is put on straight without being peeled back. If filter is put on incorrectly as shown in diagram, dust will get into motor housing, and cause motor failure. At this time, make sure to twist prefilter so that securing lip is firmly locked into cleaner unit. Always remove dust ahead of time, as suction power will be reduced if there is too much dust in cleaner. ⷠAlways be sure to check that both filter and prefilter are loaded correctly prior to using cleaner. If they are not loaded correctly, dust will get into the motor housing, and cause motor failure. [. . . ] This Warranty does not apply where: repairs have been made or attempted by others: repairs are required because of normal wear and tear: the tool has been abused, misused or improperly maintained: alterations have been made to the tool. This Warranty gives you specific legal rights, and you may also have other rights which vary from state to state. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. [. . . ]