User manual MAKITA LD100P

[. . . ] CAUTION: Indicates a potentially hazardous situation or an unintended use which, if not avoided, may result in minor injury and/or in appreciable material, financial and environmental damage. Important paragraphs which must be adhered to in practice as they enabled the product to be used in a technically correct and efficient manner. Using the instrument without instruction Using outside the stated limits Deactivation of safety systems and removal of explanatory and hazard labels Opening of the equipment by using tools (screwdrivers, etc. ), as far as not specifically permitted for certain cases Carrying out modification or conversion of the product Use after misappropriation Use of accessories from other manufacturers without the express approval of Makita. [. . . ] For measurements from a corner, open the positioning bracket until it locks in place, then push the positioning bracket lightly to the right to fold it out fully. 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 Double (partial height) measurement Illumination Save constant value, call up constant value Historical memory, call up values Battery status Timer Area/volume Tilt Horizontal distance measurement using tilt Room corner angle function Menu Continuous laser Reset Reference (tripod) Beep Circumference Wall area Ceiling area Intermediate line 1 Intermediate line 2 Intermediate line 3 Summary line See figure {E}: 1 2 3 4 5 6 7 8 9 10 11 ON (On/measuring) button Plus (+) button Minus (-) button Functions button Area / volume button Equal / menu button Memory button Indirect measurement (Pythagoras) button Clear / off button Timer button Reference button See figure {F} 1 2 3 4 5 6 7 8 Laser active Reference (front) Reference (rear) Reference (corner stop) Measuring with the tripod Stake out function Single Pythagorean measurement Double Pythagorean measurement After switching off the device or replacing the batteries the settings are stored. Setting the unit for distance measurements The following units can be set: 1. The instrument can be specifically configured to your personal requirements. Button (pressed long) brings up the MENU , the set units and the symbol are displayed. Button (pressed short) brings up the next menu item. A long press on the button in the menu confirms the new settings made in the submenu items. Pressing the button for longer in the menu allows you to quit the settings function without saving. The following units can be set for tilt measurements: Units for tilt 1. With the continuous laser function set on, each press of the button triggers a measurement. A reset returns the following values to their factory settings: · Reference (rear) Display illumination (ON) Beep (ON) Unit (m(mm)) Stack and memory are erased All customised settings and stored values are also lost. Press this button to take the first length measurement (e. Press this button to take the second length measurement (e. Press this button to take the third length measurement (e. Press the button for longer to display additional room information such as ceiling/floor area, surface area of the walls, circumference. During tilt measurement the instrument should be hold without a transverse tilt (± 10°). Press this button once to activate the tilt sensor. Press this button to take the first length measurement (e. Press it again to take the second length measurement (e. Press this button twice and the following symbol appears in the display . Two different distances (a and b) can be entered into the instrument and can then be used to mark off defined measured lengths, e. Entering stake out distances: Press this button four times and the stake out a function symbol appears in the display b . [. . . ] Make sure that the first measurement and the distance to be measured are at right angles. It is helpful to use a tripod when measuring heights that require the measurement of two or three measurements. Press this button once, the display shows The laser is switched on. The instrument can calculate distances using Pythagoras' theorem. [. . . ]