User manual MAKITA LXSL01

[. . . ] Miter angle Bevel angle 45° (left) 25 mm x 300 mm 0° (1" x 11 - 3/4") ----25 mm x 212 mm 45° (left and right) (1" x 8 - 3/8") ----0° 52 mm x 300 mm (2 - 1/16" x 11 - 3/4") * 60 mm x 265 mm (Note 1) (2-3/8" x 10-3/8") 52 mm x 212 mm (2 - 1/16" x 8 - 3/8") * 60 mm x 185 mm (Note 2) (2-3/8" x 7-1/4") ----57° (right) ----No load speed (RPM) Dimensions (L x W x H) Net weight Rated voltage Standard battery cartridge (Note) * mark indicates that a wood facing with the following thickness is used. 1: When using a wood facing 20 mm thickness 2: When using a wood facing 15 mm thickness 3: When using a wood facing 10 mm thickness · Due to our continuing programme of research and development, the specifications herein are subject to change without notice. ⷠSpecifications and battery cartridge may differ from country to country. ⷠWeight, with battery cartridge, according to EPTA-Procedure 01/2003 Learn the tool's applications and limitations, as well as the specific potential hazards peculiar to it. [. . . ] WARNING: Before installing the battery cartridge on the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. Do not pull the switch trigger hard without pressing in the lock-off button. Operating a tool with a switch that does not actuate properly can lead to loss of control and serious personal injury. WARNING: Always be sure that the tool is switched off and the battery cartridge is removed before working on the tool. Failure to switch off and remove the battery cartridge may result in serious personal injury. When the socket wrench is needed it can be pulled out of the wrench holder. After using the socket wrench it can be stored by returning it to the wrench holder. WARNING: Always be sure that the tool is switched off and the battery cartridge is removed before installing or removing the blade. Accidental start up of the tool may result in serious personal injury. If the inner flange is removed be sure to install it on the spindle with its protrusion facing away from the blade. if the flange is installed incorrectly the flange will rub against the machine. To install the blade, mount it carefully onto the spindle, making sure that the direction of the arrow on the surface of the blade matches the direction of the arrow on the blade case. Install the outer flange and hex bolt, and then use the socket wrench to tighten the hex bolt (left-handed) securely counterclockwise while pressing the shaft lock. To remove the blade, use the socket wrench to loosen the hex bolt holding the center cover by turning it counterclockwise. Press the shaft lock to lock the spindle and use the socket wrench to loosen the hex bolt clockwise. Return the blade guard and center cover to its original position. Then tighten the hex bolt clockwise to secure the center cover. Release the handle from the raised position by pulling the stopper pin. Make sure that the blade guard moves properly. Make sure the shaft lock has released spindle before making cut. The use of the dust bag makes cutting operations cleaner and dust collection easier. To attach the dust bag, fit it onto the dust nozzle. [. . . ] Take out the worn carbon brushes, insert the new ones and secure the brush holder caps. It is warranted to be free of defects from workmanship and materials for the period of ONE YEAR from the date of original purchase. Should any trouble develop during this one year period, return the COMPLETE tool, freight prepaid, to one of Makita's Factory or Authorized Service Centers. If inspection shows the trouble is caused by defective workmanship or material, Makita will repair (or at our option, replace) without charge. [. . . ]