User manual MAKITA MAC5200E

[. . . ] OWNERS MANUAL FOR Oil Lubricated Air Compressor MAC700 | MAC2400 | MAC5200 SPECIFICATION CHART Model No. Horsepower SCFM @ 40 PSIG SCFM @ 90 PSIG Cut-In Pressure Cut-Out Pressure Bore Stroke Voltage -Single Phase Motor RPM Amperage @ max pressure Tank Size CSA/US Listed MAC700 2 3. 8 3. 3 100 PSI 130 PSI 47 mm 44 mm 120 1720 12. 4 2. 6 Gallon Yes MAC2400 2. 5 4. 8 4. 2 100 PSI 130 PSI 51 mm 44 mm 120 1720 12. 3 4. 2 Gallon Yes MAC5200 3 6. 9 6. 5 110 PSI 140 PSI 47 mm 44 mm 120 3420 13. 8 5. 2 Gallon Yes MODEL NO. Minimum Circuit Requirement: 15 AMPS * A circuit breaker is preferred. Use only a fuse or circuit breaker that is the same rating as the branch circuit the air compressor is operated on. If the air compressor is connected to a circuit protected by fuses, use time delay fuses. IMPORTANT: www. makitatools. com MAC700 - 02/04 Read the Safety Guidelines and ALL instructions carefully before operating. TABLE OF CONTENTS OWNERS MANUAL TABLE OF CONTENTS SAFETY INSTRUCTIONS . [. . . ] The outlet must have the same configuration as the plug. Inspect the plug and cord before each use. Do not use if there are signs of damage. DANGER: Improper grounding can result in electrical shock. Do not modify the plug that has been provided. If it does not fit the available outlet, the correct outlet should be installed by a qualified electrician. OPERATING PROCEDURES Daily Start-Up Checklist: 1) Before attaching air hose or accessories, make sure the pressure switch lever is set to "OFF" and the air regulator or shut-off valve is closed. Too much air pressure causes a hazardous risk of bursting. Check the manufacturer's maximum pressure rating for air tools and accessories. The regulator outlet pressure must never exceed the maximum pressure rating. 3) Turn the pressure switch lever to "ON/AUTO" and allow tank pressure to build. Motor will stop when tank pressure reaches "cut-out" pressure. 4) Open the regulator by turning it clockwise. Adjust the regulator to the correct pressure setting. 5) Always operate the air compressor in well-ventilated areas; free of gasoline or other solvent vapors. Do not operate the compressor near the spray area. MAKITA - MAC700 / MAC2400 / MAC5200 11 MAINTENANCE OWNERS MANUAL OPERATING PROCEDURES . . . Continued When you are finished: 6) Set the pressure switch lever to "OFF". 7) Using the air tool or accessory, bleed the tank pressure down to zero. 9) Drain water from air tank by opening drain cock valve on bottom of tank. IF NOT DRAINED, WATER WILL CORRODE AND WEAKEN THE AIR TANK CAUSING A RISK OF AIR TANK RUPTURE. Note: If drain cock valve is plugged, release all air pressure. The valve can then be removed, cleaned, then reinstalled. 10) After the water has been drained, close the drain valve. [. . . ] 84th Street Omaha, NE 68127 (402) 597-2925 12801 Stemmons Fwy. Suite 809 Farmers Branch, TX 75234 (972) 243-1150 12701 Directors Drive Stafford, TX 77477-3701 (281) 565-8665 3453 IH-35 North, Suite 101 San Antonio, TX 78219 (210) 228-0676 Colorado 11839 E. 51st Avenue Denver, CO 80239-2709 (303) 371-2850 Nevada 3375 S. Decatur Boulevard Suites 22-24 Las Vegas, NV 89102 (702) 368-4277 Florida 750 East Sample Road Pompano Beach, FL 33064 (954) 781-6333 Georgia 4680 River Green Parkway NW Duluth, GA 30096 (770) 476-8911 New Jersey 251 Herrod Boulevard Dayton, NJ 08810-1539 (609) 655-1212 Wisconsin 2245 S. [. . . ]