User manual MAKITA MOTEUR PM5360 S3 120000

[. . . ] These numbers are located on your engine (see the Features and Controls page). The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. WARNING Date of purchase: Engine model: Model: MM/DD/YYYY Type: Code: Briggs & Stratton does not approve or authorize the use of these engines on 3-wheel All Terrain Vehicles (ATVs), motor bikes, fun/recreational go-karts, aircraft products, or vehicles intended for use in competitive events. Use of these engines in such applications could result in property damage, serious injury (including paralysis), or even death. [. . . ] Remove the spark arrester (P), if equipped, and inspect for damage or carbon blockage. If replacement parts are required, make sure to use only original equipment replacement parts. WARNING: Replacement parts must be the same and installed in the same position as the original parts or fire could result. First 5 Hours • Change oil ro d WARNING Maintenance Chart How To Change The Oil - Figure 1 uc Every 8 Hours or Daily • • • Check engine oil level Clean area around muffler and controls Clean finger guard Every 25 Hours or Annually • • Clean air filter * Clean pre-cleaner * Every 50 Hours or Annually • • Change engine oil Check muffler and spark arrester rR Annually • • • • • * Replace air filter Replace pre-cleaner Replace spark plug Replace fuel filter Clean air cooling system * fo In dusty conditions or when airborne debris is present, clean more often. Ot N Carburetor Adjustment Never make adjustments to the carburetor. However, if adjustments are required, see any Briggs & Stratton Authorized Dealer for service. NOTICE: The manufacturer of the equipment on which this engine is installed specifies the top speed at which the engine will be operated. How To Replace The Spark Plug - Figure 9 Check the gap (A, Figure 9) with a wire gauge (B). Install and tighten the spark plug to the recommended torque. For gap setting or torque, see the Specifications section. Note: In some areas, local law requires using a resistor spark plug to suppress ignition signals. If this engine was originally equipped with a resistor spark plug, use the same type for replacement. Gasoline and its vapors are extremely flammable and explosive. fire or explosion can cause severe burns or death. If you drain the oil from the top oil fill tube, the fuel tank must be empty or fuel can leak out and result in a fire or explosion. Used oil is a hazardous waste product and must be disposed of properly. Check with your local authorities, service center, or dealer for safe disposal/recycling facilities. Remove Oil You can drain the oil from the bottom drain hole, the side drain hole, or from the top oil fill tube. With engine off but still warm, disconnect the spark plug wire (A) and keep it away from the spark plug (Figure 10). The engine is equipped with a bottom drain (Q, Figure 1) and/or a side drain (R). Drain the oil into an approved container. Note: Any of the oil drain plugs (H) shown may be installed in the engine. [. . . ] Add on or modified parts that are not exempted by the Air Resources Board may not be used. The use of any non exempted add on or modified parts by the owner will be grounds for disallowing a warranty claim. The manufacturer will not be liable to warrant failures of warranted parts caused by the use of a non exempted add on or modified part. RR fo N Engines that are certified to meet the California Air Resources Board (CARB) Emissions Standard must display information regarding the Emissions Durability Period and the Air Index. [. . . ]