User manual MAKITA MS352.4C

[. . . ] ENG905-1 • Noise The typical A-weighted noise level determined according to EN60745: Sound pressure level (LpA) : 86 dB(A) Sound power level (LWA) : 97 dB(A) Uncertainty (K) : 3 dB(A) Wear ear protection ENG900-1 • WARNING: The vibration emission during actual use of the power tool can differ from the declared emission value depending on the ways in which the tool is used. Be sure to identify safety measures to protect the operator that are based on an estimation of exposure in the actual conditions of use (taking account of all parts of the operating cycle such as the times when the tool is switched off and when it is running idle in addition to the trigger time). ENH101-14 For European countries only EC Declaration of Conformity We Makita Corporation as the responsible manufacturer declare that the following Makita machine(s): Designation of Machine: Cordless Circular Saw Model No. / Type: MS352. 4C are of series production and Conforms to the following European Directives: 2006/42/EC And are manufactured in accordance with the following standards or standardised documents: EN60745 The technical documentation is kept by our authorised representative in Europe who is: Makita International Europe Ltd. [. . . ] Do not support board or panel away from the cut. € Blade depth and bevel adjusting locking levers must be tight and secure before making cut. If blade adjustment shifts while cutting, it may cause binding and kickback. € Use extra caution when making a "plunge cut" into existing walls or other blind areas. The protruding blade may cut objects that can cause kickback. Check lower guard for proper closing before each use. Do not operate the saw if lower guard does not move freely and close instantly. Never clamp or tie the lower guard into the open position. If saw is accidentally dropped, lower guard may be bent. Raise the lower guard with the retracting handle and make sure it moves freely and does not touch the blade or any other part, in all angles and depths of cut. Check the operation of the lower guard spring. Do not store the tool and battery cartridge in locations where the temperature may reach or exceed 50 ﾟ C (122 ﾟ F). Do not incinerate the battery cartridge even if it is severely damaged or is completely worn out. The battery cartridge can explode in a fire. Be careful not to drop or strike battery. Before setting the tool down after completing a cut, be sure that the lower guard has closed and the blade has come to a complete stop. Never attempt to saw with the circular saw held upside down in a vise. This is extremely dangerous and can lead to serious accidents. Some material contains chemicals which may be toxic. Take caution to prevent dust inhalation and skin contact. Do not stop the blades by lateral pressure on the saw blade. Always use blades recommended in this manual. [. . . ] This is caused by the activation of protection system and does not show the tool trouble. € When the tool is overloaded: At this time, release the switch trigger and remove causes of overload and then pull the switch trigger again to restart. € When the remaining battery capacity gets low: Recharge the battery cartridge. € WARNING: For your safety, this tool is equipped with lock-off lever which prevents the tool from unintended starting. [. . . ]