User manual MAKITA MS352.4CU

[. . . ] It is also suitable for drilling without impact in wood, metal, ceramic and plastic. Cutting accessory contacting a “live” wire may make exposed metal parts of the power tool “live” and could give the operator an electric shock. Wear a hard hat (safety helmet), safety glasses and/or face shield. Ordinary eye or sun glasses are NOT safety glasses. [. . . ] Be careful not to scratch the lens of lamp, or it may lower the illumination. € Do not use thinner or gasoline to clean the lamp. When the reversing switch lever is in the neutral position, the switch trigger cannot be pulled. CAUTION: • Always check the direction of rotation before operation. € Use the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool. € When not operating the tool, always set the reversing switch lever to the neutral position. 5) This tool has a reversing switch to change the direction of rotation. Removing the quick change chuck for SDS-plus (Fig. 6) CAUTION: • Before removing the quick change chuck for SDS-plus, always remove the bit. Grasp the change cover of the quick change chuck for SDS-plus and turn in the direction of the arrow until the change cover line moves from the symbol to the symbol. 4) CAUTION: • Do not look in the light or see the source of light directly. Pull the switch trigger to light up the lamp. The lamp keeps on lighting while the switch trigger is being pulled. The light automatically goes out 10 - 15 seconds after the switch trigger is released. 8 CAUTION: • Do not rotate the action mode changing knob when the tool is running. Adjust the depth gauge to the desired depth and tighten the side grip. NOTE: • The depth gauge cannot be used at the position where the depth gauge strikes against the gear housing. Torque limiter The torque limiter will actuate when a certain torque level is reached. The motor will disengage from the output shaft. When this happens, the bit will stop turning. CAUTION: • As soon as the torque limiter actuates, switch off the tool immediately. [. . . ] To change the bit angle, depress the lock button and rotate the action mode changing knob to the O symbol. Depress the lock button and rotate the action mode changing knob to the symbol. Then make sure that the bit is securely held in place by turning it slightly. 20) After drilling the hole, use the blow-out bulb to clean the dust out of the hole. [. . . ]