User manual MAKITA MT901

[. . . ] INSTRUCTION MANUAL Angle Grinder MT900 MT901 006770 DOUBLE INSULATION WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. 1 ENGLISH SPECIFICATIONS Model Depressed center wheel diameter Spindle thread No load speed (min-1) Overall length Net weight Safety class · Note: Specifications may differ from country to country. END202-2 MT900 180 mm M14 8, 500 468 mm 4. 7 kg /II MT901 230 mm M14 6, 600 468 mm 4. 7 kg · Due to our continuing programme of research and development, the specifications herein are subject to change without notice. Symbols The following show the symbols used for the equipment. Be sure that you understand their meaning before use. [. . . ] Have your tool repaired by a qualified person. This electric tool is in accordance with the relevant safety requirements. Repairs should only be carried out by qualified persons using original spare parts, otherwise this may result in considerable danger to the user. ENB031-6 ADDITIONAL SAFETY RULES 1. Other personal protective equipment such as dust mask, gloves, helmet and apron should be worn. Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. Use only wheels with correct size and wheels having a maximum operating speed at least as high as the highest No Load Speed marked on the tool's nameplate. When using depressed center wheels, be sure to use only fiberglass-reinforced wheels. Check the wheel carefully for cracks or damage before operation. Replace cracked or damaged wheel immediately. Observe the instructions of the manufacturer for correct mounting and use of wheels. 2. 3. 25. 26. 27. Handle and store wheels with care. Do not use separate reducing bushings or adaptors to adapt large hole abrasive wheels. Use only flanges specified for this tool. Do not damage the spindle, the flange (especially the installing surface) or the lock nut. Damage to these parts could result in wheel breakage. For tools intended to be fitted with threaded hole wheel, ensure that the thread in the wheel is long enough to accept the spindle length. Before using the tool on an actual workpiece, test run the tool at the highest no load speed for at least 30 seconds in a safe position. Stop immediately if there is any vibration or wobbling that could indicate poor installation or a poorly balanced wheel. Check that the workpiece is properly supported. Make sure the wheel is not contacting the workpiece before the switch is turned on. Use the specified surface of the wheel to perform the grinding. Do not use cutting off wheel for side grinding. [. . . ] Inner flange ASSEMBLY · CAUTION: Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. 006775 Installing side grip (handle) Mount the inner flange onto the spindle. Fit the wheel/disc on the inner flange and screw the lock nut onto the spindle. For Australia and New Zealand 45 1 2 3 102 1. Inner flange 006773 006776 CAUTION: · Always be sure that the side grip is installed securely before operation. [. . . ]