User manual MAKITA PC7314D

[. . . ] On SAFETY REQUIREMENTS - Your lawnmower should be used with due care and attention. Symbols have therefore been placed on various parts of the machine to remind you of the main precautions to be taken. Their full meanings are explained later on. You are also asked to carefully read the safety regulations in the applicable chapter of this handbook. [. . . ] €“ when transporting the equipment. 19) Stop the engine: – every time you remove or replace the grass-catcher. €“ before adjusting the grass cutting height. 20) When mowing, always keep to a safe distance from the rotating blade. This distance is the length of the handle. D) MAINTENANCE AND STORAGE 1) Keep all nuts, bolts and screws tight to be sure the equipment is in safe working condition. regular maintenance is essential for safety and performance. 2) To reduce the fire hazard, keep the lawnmower, especially the engine, free of grass, leaves, or excessive grease. Do not leave containers with grass cuttings in rooms. 3) Check the stone-guard and grass-catcher frequently for wear and deterioration. 4) Periodically check the electric cables and replace them if they are damaged or if the insulation has been damaged. FINISH ASSEMBLY NOTE – The machine can be supplied with some of the components already fitted. While cutting, ensure that the electric cable is always behind you and on the area of grass already cut. The lawn will look better if it is always cut to the same height and in alternate directions. When you have finishing mowing, release the lever (1). FIRST disconnect the cable extension from the supply socket (2) and THEN from the side of the lawnmower’s switchgear (3). WAIT FOR THE BLADE TO STOP before carrying out any type of work on the machine. 1 Attach the stone-guard by inserting the pin (1) and the spring (2) as shown. First, insert the pin into the righthand housing (4). Next fit the eyelet end (3) of the spring into the central slot, and lastly insert the other end of the pin in place (5). 2 Insert the lower right part (1) and lower left part (2) of the handle into the respective holes and lock into position with the screws (3) supplied. Attach the upper part of the handle (4) to the lower parts using the knobs (5) and the nuts and bolts supplied as shown. [. . . ] Do not use forced water and avoid wetting the motor or the electrical components. Do not use harsh products for cleaning the chassis. GRASS CUTTING Lift the stone-guard and attach the grass-catcher (1) correctly as shown in the drawing. Start the engine by pressing the safety push-button (2) and pulling the switchgear lever (1). [. . . ]