User manual MAKITA PJ7000

[. . . ] Hold power tool by insulated gripping surfaces, because the blade may contact its own cord. Cutting a "live" wire may make exposed metal parts of the power tool "live" and could give the operator an electric shock. Use only the blades specified for this tool. Never operate the tool with the blade locked in exposed position or without the blade cover secured properly in place. [. . . ] For continuous operation, press the front of the slide switch to lock it. Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. When installing the plate joiner blade, mount the inner flange with the side marked "22" facing toward you. to remove the blade , loosen the clamp screw and open the blade cover. Push the shaft lock and loosen the lock nut using the lock nut wrench. to install the blade , first mount the inner flange. Securely tighten the lock nut using the lock nut wrench. Close the blade cover and tighten the clamp screw to secure the blade cover. cAUTION: · Use only Makita lock nut wrench provided to remove or install the blade. ⷠAlways check the depth of groove after replacing the blade. Remove the angle guide according to the need of your work when using the tool with the angle of the fence adjusted to other than 0°. When you need to use the angle guide under the above condition, be sure to adjust the depth of groove to get a proper depth. The angle of the fence can be adjusted between 0° and 90° (positive stops at 0°, 45° and 90°). To adjust the angle, loosen the lock lever and tilt the fence until the pointer points to the desired graduation on the angle scale. Then tighten the lock lever to secure the fence. When the fence is set at 90°, both the distance from the center of the blade thickness to the fence and the distance from the center of the blade thickness to the bottom of the blade cover are 10 mm. Before plugging in the tool, always check to see that the slide switch actuates properly and returns to the "OFF" position when the rear of the slide switch is depressed. ⷠSwitch can be locked in "ON" position for ease of operator comfort during extended use. To attach the dust bag, fit it onto the dust nozzle. If the dust bag becomes an obstacle to your work, turn the dust nozzle to change the dust bag position. [. . . ] If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. Some items in the list may be included in the tool package as standard accessories. They may differ from country to country. Noise The typical A-weighted noise level determined according to EN60745: Sound pressure level (LpA): 86 dB (A) Sound power level (LWA): 97 dB (A) Uncertainty (K): 3 dB (A) Wear ear protection We Makita Corporation as the responsible manufacturer declare that the following Makita machine(s): Designation of Machine: Plate Joiner Model No. [. . . ]