User manual MAKITA PLM4611 PARTS LIST

[. . . ] Keep other people at a safe distance whilst working. Warning: Remove the spark plug lead and read instructions before carrying out any repair or maintenance. Do not put hands or feet near the blades. Get familiar with the controls and proper use of the equipment. [. . . ] 3) Allow the engine to cool before storing in an enclosed space. 4) To reduce the fire hazard, keep the engine, exhaust silencer, battery compartment and fuel storage area free of grass, leaves, or excessive grease. Do not leave containers with grass cuttings in rooms. 5) Check the stone-guard and grass-catcher frequently for wear and deterioration. 6) If the fuel tank has to be drained, this should be done outdoors and when the engine is cool. 7) Wear strong work gloves when removing and reassembling the blade. For safety reasons, these jobs are best carried out at a specialized centre. 9) For reasons of safety, do not use the equipment with worn or damaged parts. Parts are to be replaced and not repaired. Use genuine spare parts (blades should always bear the symbol ). Parts that are not of the same quality can damage the equipment and be dangerous for your safety. With the plastic part (11) upside-down, fasten the frame (12) to the plastic part using the screws (13). Insert the frame (12) into the sack (14) and attach the plastic profile (15) with the help of a screwdriver, as shown in the drawing. Fit the edge of the cloth (16) right into the groove of the plastic part (11), starting 5-7 mm from the ends. IMPORTANT ­ Regular, careful maintenance is essential for keeping the safety level and original performance of the machine unchanged in time. 1) Wear strong working gloves during any cleaning, maintenance or adjustment operation on the machine. 2) Carefully clean the machines with water after each cut; remove the grass debris and mud accumulated inside the chassis to avoid their drying and thus making the next start-up difficult. 3) The paintwork on the inside of the chassis may peel off in time due to the abrasive action of the cut grass; in this case, intervene promptly by touching up the paintwork using a rustproof paint to prevent the formation of rust that would lead to corrosion of the metal. 4) Should it be necessary to access the lower part, only tilt the machine from the side shown in the engine handbook; following the relative instructions. 5) Do not drip petrol onto the plastic parts of the motor or the machine to prevent damaging them and remove all traces of spilt petrol immediately. The warranty does not cover damage to plastic parts caused by petrol. Some models have a fixed speed, and therefore no need of a throttle (2). [. . . ] Gradually turn register (2) anticlockwise (so as to cause it to extend) until control lever (1) has difficulty in reaching position «4»; at this point turn the register clockwise by about half a turn, to obtain optimal adjustment of the forward speed, together with correct engagement of the four speeds using control lever (1). The move from one speed to another must be made with the engine running and drive engaged. IMPORTANT - Do not touch the speed changer when the engine is stopped. This operation could damage the speed changer. [. . . ]