User manual MAKITA PS340

[. . . ] Do not short the battery cartridge: (1) Do not touch the terminals with any conductive material. A battery short can cause a large current flow, overheating, possible burns and even a breakdown. Do not store the tool and battery cartridge in locations where the temperature may reach or exceed 50°C (122°F). Do not incinerate the battery cartridge even if it is severely damaged or is completely worn out. [. . . ] Be aware that this tool is always in an operating condition, because it does not have to be plugged into an electrical outlet. Hold tool by insulated gripping surfaces when performing an operation where the cutting tool may contact hidden wiring. Contact with a “live” wire will also make exposed metal parts of the tool “live” and shock the operator. Be sure no one is below when using the tool in high locations. Do not touch the drill bit or the workpiece immediately after operation; they may be extremely hot and could burn your skin. 1) • Always switch off the machine before insertion or removal of the battery cartridge. € To remove the battery cartridge, pull out the set plate on the machine and grasp both sides of the cartridge while withdrawing it from the machine. € To insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Be sure to close the set plate fully before using the machine to prevent the battery cartridge from accidentally falling out of the machine. € Do not use force when inserting the battery cartridge. If the cartridge does not slide in easily, it is not being inserted correctly. NOTE: • Make sure that the driver bit is inserted straight in the screw head, or the screw and/or bit may be damaged. € When driving wood screws, predrill pilot holes to make driving easier and to prevent splitting of the workpiece. 6 for DA391D) CAUTION: • Before inserting the battery cartridge into the machine, always check to see that the switch trigger actuates properly and returns to the “OFF” position when released. € Always check the direction of rotation before operation. € Use the reversing switch lever only after the machine comes to a complete stop. Changing the direction of rotation before the machine stops may damage the machine. € When not operating the machine, keep the reversing switch lever in the neutral position. To start the machine, simply pull the trigger. Machine speed is increased by increasing pressure on the trigger. When the reversing switch lever is in the neutral position, the machine will not start even if you pull the trigger. 7) The overload protector automatically cuts out to break the circuit and the button pops out, whenever heavy work is prolonged. [. . . ] Wait 20 – 30 seconds before pressing the restart button to resume operation. Your finger should not be on the trigger when you press the restart button, however. 4 MAINTENANCE CAUTION: Always be sure that the machine is switched off and the battery cartridge is removed before carrying out any work on the machine. To maintain product safety and reliability, repairs, maintenance or adjustment should be carried out by a Makita Authorized Service Center. [. . . ]