User manual MAKITA PS3410TH

[. . . ] Always follow safety precautions in the Owner’s and Safety Manual. The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. PS-3410 TH EMISSIONS COMPONENT DEFECT WARRANTY COVERAGE DOLMAR warrant to the initial retail purchaser and each subsequent owner, that this utility equipment was designed, built, and equipped to conform at the time of initial sale to all applicable regulations of the U. Environmental Protection Agency (EPA), and that the engine is free of defects in materials and workmanship which would cause this engine to fail to conform with EPA regulations during its warranty period. [. . . ] When cutting small logs, use a sawhorse (fig. Never permit another person to hold the log. Never hold the log with your leg or foot. 15 Maintenance and Repair Never operate a chain saw that is damaged, improperly adjusted or not completely or securely assembled. Follow the maintenance and repair instructions in the appropriate section of this manual. 33 Always stop the engine and make sure that the chain is stopped before commencing any maintenance or repair work or cleaning the saw. Do not attempt any maintenance or repair work not described in this manual. Have such work performed by your DOLMAR service shop only. Maintaining and storing the saw Keep the chain, bar and sprocket clean and lubricated; replace worn sprockets or chains. Logs under strain require special attention to prevent the saw from pinching. The first cut is made on the compression side to relieve the stress on the log (see fig. If the saw pinches, stop the engine and remove it from the log. You can spot a dull chain when easy-to-cut wood becomes hard to cut and burn marks appear on the wood. Tighten all nuts, bolts and screws except the carburetor adjustment screws after each use. Keep spark plug and wire connection tight and clean. Only properly trained professionals should work in an area where the logs, limbs and roots are tangled (i. Drag the logs into a clear area before cutting. XXX Typ 170 Indicate when ordering spare parts!Engine speed with bar and chain rpm 3, 000 / 11, 500 Coupling speed rpm 4, 500 Sound Pressure Level at the operator’s ear at full load according to ANSI B 175. 4 Sound Pressure Level at the bystander’s position (50 ft/15 m distance) according to ANSI B 175. 44 Mix ratio (fuel/two-stroke oil) 50 : 1 (2%) - when using DOLMAR oil - when using other oils 40 : 1 (oil quality must be JASO FC or ISO EGD) Chain brake engages manually or in case of kickback Chain speed 2) m/s 21 Sprocket pitch inch 3/8 Number of teeth Z 6 Chain type - see the Extract from the spare-parts list Pitch / Driving element strength inch 3/8 / . Power WARNING: This chain saw is capable of severe kickback that coult result in serious injury to the user. [. . . ] He will also have the spare part lists to determine the required spare part numbers, and will be constantly informed about the latest improvements and spare part innovations. Please bear in mind that if parts other than original DOLMAR spare parts are used, this will automatically invalidate the DOLMAR product guarantee. Spare parts DOLMAR guarantees the highest quality and will therefore reimburse all costs for repair by replacement of damaged parts resulting from material or production faults occurring within the guarantee period after purchase. Please note that in some countries particular guarantee conditions may exist. [. . . ]