User manual MAKITA PS5000D

[. . . ] eNE001-1 General Power Tool Safety Warnings GEA010-1 WARNING Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. cORDLESS PLANER SAFETY WARNINGS GEB064-1 1. [. . . ] 2) The battery cartridge with a star mark is equipped with the protection system, which automatically cuts off the output power for its long service life. The tool stops during operation when the tool and/or battery are placed under the following situation. This is caused by the activation of protection system and does not show the tool trouble. €¢ When the tool is overloaded: At this time, release the switch trigger, remove the battery cartridge and remove causes of overload and then pull the switch trigger again to restart. €¢ When battery cells get hot: If any operation of the switch trigger, the motor will remain stopped. At this time, stop use of the tool and cool or charge the battery cartridge after removing it from the tool. €¢ When the remaining battery capacity gets low: If any operation of the switch trigger, the motor will remain stopped. At this time, remove the battery cartridge from the tool and charge it. 3) Depth of cut may be adjusted by simply turning the knob on the front of the tool so that the pointer points the desired depth of cut. 4) CAUTION: • Before installing the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the “OFF” position when released. €¢ Do not pull the switch trigger hard without pressing the lock-off lever. Tighten the three hex flange head bolts (with the socket wrench provided) and rotate the drum to check clearances between the blade ends and the tool body. Check the three hex flange head bolts for final tightness. Repeat procedures 1 - 9 for the other blade. The blade must be mounted so that the cutting edge is absolutely level, that is, parallel to the surface of the rear base. Refer to some examples below for proper and improper settings. This prevents the tool blades to be damaged. ASSEMBLY CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. Removing or installing planer blades CAUTION: • Tighten the blade installation bolts carefully when attaching the blades to the tool. A loose installation bolt can be dangerous. Always check to see they are tightened securely. €¢ Handle the blades very carefully. [. . . ] Apply pressure on the front of tool at the start of planing, and at the back at the end of planing. Planing will be easier if you incline the workpiece in stationary fashion, so that you can plane somewhat downhill. The speed and depth of cut determine the kind of finish. The power planer keeps cutting at a speed that will not result in jamming by chips. [. . . ]