User manual MAKITA RBLV250 DC24WA

[. . . ] Do not point the tool at any one in the area when operating. The bit could fly out and injure someone seriously. Do not touch the bit or parts close to the bit immediately after operation; they may be extremely hot and could burn your skin. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. [. . . ] Use a bull point, cold chisel, scaling chisel, etc. cAUTION: · When using the tool in the symbol mode, the switch trigger does not work and only the slide switch works. Use a bull point, cold chisel, scaling chisel, etc. cAUTION: · Do not rotate the change lever when the tool is running under load. To avoid rapid wear on the mode change mechanism, be sure that the change lever is always positively located in one of the two or three action mode positions. The revolutions and blows per minute can be adjusted just by turning the adjusting dial. the dial is marked 1 (lowest speed) to 5 (full speed). Refer to the table below for the relationship between the number settings on the adjusting dial and the revolutions/ blows per minute. The torque limiter will actuate when a certain torque level is reached. As soon as the torque limiter actuates, switch off the tool immediately. This will help prevent premature wear of the tool. After drilling the hole, use the blow-out bulb to clean the dust out of the hole. Turn the tool on and apply slight pressure on the tool so that the tool will not bounce around, uncontrolled. Pressing very hard on the tool will not increase the efficiency. Clean the bit shank and apply bit grease before installing the bit. Turn the bit and push it in until it engages. Pull the chuck cover down a couple of times. Turn the bit and push it in until it engages. After installing, always make sure that the bit is securely held in place by trying to pull it out. To remove the bit, pull the chuck cover down all the way and pull the bit out. Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. This tool requires no hourly or daily lubrication because it has a grease-packed lubrication system. [. . . ] 5 m/s2 Uncertainty (K): 2 m/s2 For Model HR4511C For European countries only Noise ENG102-2 The typical A-weighted noise level determined according to EN60745: Sound pressure level (LpA): 94 dB (A) Sound power level (LWA): 105 dB (A) Uncertainty (K): 3 dB (A) Wear ear protection. Vibration ENG216-2 The vibration total value (tri-axial vector sum) determined according to EN60745: Work mode: chiseling function with side handle Vibration emission (ah, CHeq): 7 m/s2 Uncertainty (K): 1. Work mode: chiseling function with side grip Vibration emission (ah, CHeq): 7. Work mode: hammer drilling into concrete Vibration emission (ah, HD): 7. [. . . ]