User manual MAKITA SC120DA

[. . . ] Do not charge Battery Cartridge when temperature is BELOW 10°C (50°F) or ABOVE 40°C (104°F). Do not attempt to use a step-up transformer, an engine generator or DC power receptacle. Do not allow anything to cover or clog the charger vents. Always cover the battery terminals with the battery cover when the battery cartridge is not used. [. . . ] Keep hands away from blades and surrounding areas. To remove the battery cartridge, pull out the set plate and withdraw the battery cartridge from the machine. To install the battery cartridge, align its tongue with the groove in the housing and slip it into place. The charging light will flash in green color. Insert the battery cartridge so that its plus and minus terminals are on the same sides as their respective markings on the fast charger. The charging light color will change from green to red and charging will begin. The charging light will remain lit steadily during charging. When the charging light color changes from red to green and a tone sounds steadily for approx. Unplug the charger from the power source. If the battery cartridge is new, or has not been used for a long time, it may not accept a full charge. You can recharge the battery cartridge fully after discharging it completely a couple of times. If the charging light flashes alternately in green and red, and a tone sounds "beep, beep, beep, . " , a problem exists and charging is not possible. The terminals on the charger or battery cartridge are clogged with dust or the battery cartridge is worn out or damaged. ⷠIf charging two battery cartridges in succession, give the charger 15 minutes to cool down between the two. CAUTION: Before inserting the battery cartridge into the machine, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. Important: Always be sure that the machine is switched off and the battery cartridge is removed before replacing the stopper. the stopper for M8 or M10 blades is factory-installed on the machine. When cutting M12 threaded rods, replace the stopper for M8 or M10 blades with the stopper for M12 blades which is provided as standard equipment. to replace the stopper , remove the bolt which secures it. Install the stopper on the machine with its claw facing forward or upward. The speed varies from 0 to maximum, depending on the pressure applied to the trigger. [. . . ] Release the trigger just before the threaded rod is completely. Remove the hex bolt which caps the oil hole. Replenish oil, being careful not to allow any oil into the motor. Repeat the above procedures two or three times. [. . . ]