User manual MAKITA TD0101

[. . . ] Noise The typical A-weighted noise level determined according to EN60745: Sound pressure level (LpA) : 90 dB(A) Sound power level (LWA) : 101 dB(A) Uncertainty (K) : 3 dB(A) Wear ear protection We Makita Corporation as the responsible manufacturer declare that the following Makita machine(s): Designation of Machine: Impact Driver Model No. / Type: TD0101, TD0101F are of series production and Conforms to the following European Directives: 98/37/EC until 28th December 2009 and then with 3 2006/42/EC from 29th December 2009 And are manufactured in accordance with the following standards or standardised documents: EN60745 The technical documentation is kept by our authorised representative in Europe who is: Makita International Europe Ltd, Michigan, Drive, Tongwell, Milton Keynes, MK15 8JD, England CAUTION: Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. 1 CAUTION: Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. to start the tool , simply pull the switch trigger. [. . . ] Changing the direction of rotation before the tool stops may damage the tool. DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to safety rules for the subject product. MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. CAUTION: Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. To install these types of bits, follow the procedure (1). To install these types of bits, follow the procedure (2). To install the bit, pull the sleeve in the direction of the arrow and insert the bit into the sleeve as far as it will go. 6 To remove the bit, pull the sleeve in the direction of the arrow and pull the bit out firmly. nOTE: · If the bit is not inserted deep enough into the sleeve, the sleeve will not return to its original position and the bit will not be secured. In this case, try re-inserting the bit according to the instructions above. The size of wood screw which can be fastened with this tool may differ depending upon the type of material to be fastened. Always perform a test operation to determine the size of wood screw. Holding the tool Hold the tool only by the handle when performing an operation. The proper fastening torque may differ depending upon the kind or size of the screw/bolt, the material of the workpiece to be fastened, etc. Apply forward pressure to the tool to the extent that the bit will not slip off the screw and turn the tool on to start operation. nOTE: · Use the proper bit for the head of the screw/bolt that you wish to use. When fastening screw M8 or smaller, carefully adjust pressure on the switch trigger so that the screw is not damaged. To install the bit, pull the sleeve in the direction of the arrow and insert the bit-piece and bit into the sleeve as far as it will go. The bit-piece should be inserted into the sleeve with its pointed end facing in. If you tighten the screw for a time longer than shown in the figures, the screw or the point of the driver bit may be overstressed, stripped, damaged, etc. [. . . ] To remove, loosen the screw and then take it out. 11 To use the adjustable locator with bit, remove the bumper and then install it. CAUTION: Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. Replace when they wear down to the limit mark. [. . . ]