User manual MAKITA UM3830

[. . . ] Important: Read this instruction manual carefully before using the trimmer, and strictly observe the safety regulations!We trust that you will be a satisfied customer. you have chosen one of the latest models of MAKITA eletric trimmer. With its modern design, the UM3830, UM4030 is the ideal helper for lawn care, flower beds and path borders. [. . . ] Always be careful to maintain a steady footing. During breaks and when leaving the trimmer unattended, switch it off (7) and place it in such a way that no-one can be endangered. When moving from place or place or carrying the trimmer, switch if off (7). Work only in good light and with a clear view. Be aware of any obstacles that may cause you to stumble! on slopes and uneven terrain there is the danger of slipping!Never use the trimmer while standing on a ladder. Otherwise these objects can ricochet (injury hazard, 8) as well as damage the cutting tool. The cutting tool must be rotating at full speed before you begin to cut. When trimming, swing the trimmer in a semicircle from right to left (similar to a sickle). Use the cutting tool (9) only for the types of work described!2-line trimmer head: Use only for cutting grass and weeds near fences, walls, edges, trees, posts etc. Do not use metal cutting tools with this electric trimmer!During transportation or carrying, and when changing work locations, switch off the trimmer to prevent the strimmer head from starting unintentionally. Never carry or transport the electric trimmer while the trimmer head is rotating!When transporting the trimmer in a vehicle make sure the trimmer is in a secure position. Regularly clean out any grass that accumulates between the trimmer head and its fitting. Never clean the motor housing by spraying it with water. Do not use strong cleaning agents that may damage the plastic of the housing. Let the trimmer dry thoroughly after cleaning!Keep the ventilation slots on the motor housing clear of any debris. Be especially careful when cleaning the guard near the trimmer head (injury hazard). [. . . ] If this is not the case, re-insert the line. Turn the spool button (B/1) in the direction of the arrow (stamped on the housing cover) until only about 15 cm (6") of each line protrudes from the trimmer hed. Any maintenance or adjustment work not described in this manual may be performed only by a MAKITA service location. Fault Motor doesn't work Cause No power supply Cable defective, plug defective, ON/OFF switch defective, motor defective Poor peformance Trimmer head does not rotate Poor trimming results Trimmer line cannot be Adjusted during operation Carbon brushes worn Grass or debris blocking the head Flexible shaft in shaft tube defective Tirmmer line too short Tirmmer line too short Tirmmer line used up Tirmmer line improperly wound Dirty The maintenance and repair of modern electric trimmers and their safety features require qualified training and a workshop with special tools and test equipment. [. . . ]