User manual MAKITA UT120

[. . . ] All rights of changes due to technical development reserved. Read and obey these instructions before using this machine. [. . . ] also wear a dust mask and thickly padded gloves. Prior to work starting, make sure that cutting accessory is fitted properly. Keep hands well away from rotating parts. Do not leave the machine running unattended. To avoid machine self-starting, always trigger-off the switch should power supply become interrupted or plug accidentally withdrawn from the socket while motor is still running. When machine is used outdoors, only use extension cords intended and approved for such application by complying with your local regulations. Always have mains cable routed to the rear and away from the machine and moving parts. Keep sure-footing and body balance at all times for better control of reaction torque. Hence, the following instruction should be observed: Use only Makita paddles with M14 internal thread. do not allow blocking of the tool due to overload. The operating voltage must correspond with that indicated on identification plate. Mashines designed for 110 V can be used with 120 V as well. [. . . ] The typical A/weighted noise levels are sound pressure level: sound power level: Wear ear protection The typical weighted root mean square acceleration value is not 2 more than 2. We declare under our sole responsibility that this product is in compliance with the following standards or standardized documents, EN50144, HD400 in accordance with Council Directives, 89/336/EEC and 98/37/EC [. . . ]