User manual MAKITA UT1305

[. . . ] END201-2 Symbols The following show the symbols used for the equipment. Be sure that you understand their meaning before use. DOUBLE INSULATION Intended use ENE056-1 The tool is intended for mixing wall materials, etc. (except flammable materials) Power supply ENF002-1 The tool should be connected only to a power supply of the same voltage as indicated on the nameplate, and can only be operated on single-phase AC supply. [. . . ] Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. For continuous operation, pull the switch trigger and then push in the lock button. To stop the tool from the locked position, pull the switch trigger fully, then release it. Hold the rear handle of the tool with one hand and the grip with the other hand firmly, place the mixing blade under material fully and turn on the tool after making sure work site safety. Move the mixing blade up and down during the mixing operation so that whole part of material can be mixed. When finishing mixing, turn off the tool, make sure that the mixing blade has come to a complete stop, and then pull it out of the vessel. Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. Insert the slotted bit screwdriver and the like between the tool and the cover as shown in the figure. lift it up just like using a shovel and remove the cover. Replace the filter in the cover with a new one. The green power-ON indicator lamp lights up when the tool is plugged to the mains. If the indicator lamp is lit but the tool does not start even if the tool is switched ON, the carbon brushes may be worn out, or the motor or the switch may be defective. If the indicator lamp does not light up, the mains cord or the indicator lamp may be defective. When the mains cord is defective, the tool neither starts nor lights the indicator lamp. When the indicator lamp is defective, the tool starts without the indicator lamp lighting up. Replace when they wear down to the limit mark. Keep the carbon brushes clean and free to slip in the holders. Both carbon brushes should be replaced at the same time. Take out the worn carbon brushes, insert the new ones and secure the brush holder caps. 9) To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized Service Centers, always using Makita replacement parts. [. . . ] Innan du ansluter maskinen till elnätet ska du kontrollera att avtryckaren fungerar och återgår till läget "OFF" när du släpper den. The typical A-weighted sound pressure level is 82 dB (A). The noise level under working may exceed 85 dB (A). ­ The typical weighted root mean square acceleration value is not more than 2. [. . . ]