User manual MANFROTTO 521

[. . . ] Never connect controller to any other jack, which does not have the LANC logo. it may even result in permanent controller and/or camera damage!LANC controller is designed as a standalone control system for video cameras - it is not designed to work simultaneously with other LANC control systems Model 521P 1. Switch the camera ­ now you may start using the controller Remote Zoom Controller is designed to work only with PANASONIC AG-DVX100 and AG-DVC80 video cameras, which have the 2. [. . . ] press the button again to stop recording. OPERATION ­ model 521PRO NOTE: Not all function may be available depending on camera working mode e. If using Sony camera Memory mode the "Record start/stop" functions are not working. Selecting zoom speed limit mode Press the zoom speed button. The zoom mode LED should light below or above the button indicating zoom speed limit mode. Selecting zoom mode To choose between zoom modes, press the zoom speed button. When you press the button for the first time, the "P" LED below the button will go on, indicating that you work in progressive mode with zoom speed limit. Pressing the button for the second time will make the "F" LED above the button to go on and the "P" LED to go off, indicating that you work in fixed zoom speed mode with zoom speed limit. Pressing the button for the third time, will make the LEDs to go off, indicating that you work in default mode ­ progressive zoom speed mode with no zoom speed limit. The more angle the knob is rotated the faster zoom speed is. The more angle the knob is rotated the faster zoom speed is. if the LED "P" is on , maximum zoom speed is limited to the pre-set zoom speed. Fixed mode zoom Works only, if fixed zoom mode is selected. rotate the knob right (or left , dependent on the zoom direction) to zoom tele. Zoom speed is always constant, limited to the pre-set speed indicated by LED. rotate the knob left (or right , dependent on the zoom direction) to zoom wide. Zoom speed is always constant, limited to the pre-set speed indicated by LED. Customizing zoom speed limit Rotate the zoom wheel and zoom with any speed you prefer. While zooming, keep it pressed for approx. 1 sec, until the LED indicator will light off. The new speed limit will be saved in microcontroller internal flash memory and restored after each power off. You may always reset the zoom speed to predefined factory setup (see. [. . . ] Electrical precaution The cable is always one of the most easy breakable element of any electronic system, especially when as exposed to mechanical wear off. Therefore to extend the life of your controller and make the basic "repair" as cheap as possible we decided to allow easy cable exchange. However, to avoid accidental short circuiting the camera connection, you must remember to always plug the cable to the controller first. We advise you to not to remove the cable from the controller, if it is not necessary. [. . . ]