User manual MARANTZ PM-11S1

[. . . ] Model PM-11S1 User Guide Integrated Amplifier ENGLISH WARRANTY For warranty information, contact your local Marantz distributor. RETAIN YOUR PURCHASE RECEIPT Your purchase receipt is your permanent record of a valuable purchase. It should be kept in a safe place to be referred to as necessary for insurance purposes or when corresponding with Marantz. IMPORTANT When seeking warranty service, it is the responsibility of the consumer to establish proof and date of purchase. [. . . ] For more information on the FCBS, see "ABOUT FCBS" on pg. Also, the OPERATE indicator flashes if a protective circuit trips. For troubleshooting procedures, see "TROUBLESHOOTING" on pg. 22. !5 Power Indicator This indicator is lit a blue color while power to the PM11S1 is ON. 11 ENGLISH NAMES AND FUNCTIONS OF PARTS ENGLISH REAR PANEL 3 2 1 2 3 1 AC IN A PHONO GND Terminal Connect the grounding wire from an analog record player here. H PREOUT Jacks These jacks are for connecting to the input jacks of another main amplifier or active subwoofer. Output signals can be turned ON/OFF from the PRE OUT button on the front panel. In the bi-amp mode, the signals input to the L channel are output to both output jacks. B PHONO Input Jacks These jacks are for connecting to an analog record player. Both MC and MM cartridges can be used, therefore set the PHONO MC button on the front panel according to the type of cartridge you are using. In the bi-amp mode, the R channel jack cannot be used. I SPEAKER SYSTEMS Output Terminals You can connect 2 speaker systems to the PM-11S1. Speaker output can be turned ON/OFF from the SPEAKER A and B buttons on the front panel. In the bi-amp mode, the signals input to the L channel are output to both output terminals. C BALANCED INPUT Jacks These jacks are for connecting to the balanced output jacks of a CD player or D/A converter. With the BALANCED INPUT jacks of the PM-11S1, pin 1 is GND, pin 2 is Cold and pin 3 is Hot. In the bi-amp mode, the R channel jack cannot be used. J F. C. B. S. IN/OUT Jacks You can connect and synchronize up to four PM-11S1s in a complete bi-amp connection or multi-channel connection. A stereo miniplug or monaural miniplug cable can be used for the connections. For instructions on use and connections, see "ABOUT FCBS" on pg. 17. D CD Input Jacks These jacks are for connecting to the output jacks of a Super Audio CD player, CD player, etc. In the bi-amp mode, the R channel jack cannot be used. E LINE 1/2 Input Jacks These jacks are for connecting to the output jacks of a tuner, DVD player, etc. In the bi-amp mode, the R channel jack cannot be used. K Operating Mode Switch This switch is for setting the operating mode of the PM11S1. STEREO: Set to use the PM-11S1 as an ordinary 2-channel stereo amplifier. BI-AMP: Set to use two PM-11S1s in a complete bi-amp connection with FCBS. For more information on the bi-amp mode, see "ABOUT THE BI-AMP MODE" on pg. 17. F RECORDER 1/2 IN Jacks These jacks are for connecting to the output jacks of a CDR, MD deck, tape deck, etc. [. . . ] 240mV/20k CD/LINE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 240mV/20k Output voltage/Output impedance PRE OUT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1. 9 V/220 Maximum allowed PHONO input (1kHz) MC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12mV MM . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]