User manual MARANTZ PM6003

[. . . ] SVENSKA ITALIANO ESPAÑOL NEDERLANDS DEUTSCH FRANÇAIS ENGLISH Integrated Amplifier PM6003 ENGLISH WARRANTY For warranty information, contact your local Marantz distributor. RETAIN YOUR PURCHASE RECEIPT Your purchase receipt is your permanent record of a valuable purchase. It should be kept in a safe place to be referred to as necessary for insurance purposes or when corresponding with Marantz. IMPORTANT When seeking warranty service, it is the responsibility of the consumer to establish proof and date of purchase. [. . . ] · On wobbly, inclined or otherwise unstable surfaces · Radiated heat is blocked such as in cramped audio racks. KEEP OBJECTS OFF Keep objects off the PM6003. Blocking the vent can result in accident and damage. DO NOT TOUCH HOT SPOTS DURING AND IMMEDIATELY AFTER USE During and immediately after use, the PM6003 is hot in areas other than the controls and rear panel connection jacks. Do not touch hot spots and especially the top panel. Contact with hot areas can cause burns. 2 ENGLISH FOR USE OF REMOTE CONTROLLER LOADING BATTERIES Before using the remote controller for the first time, load the batteries in the remote controller. The batteries provided are used to verify the operations of the remote controller only. CAUTIONS ON HANDLING BATTERIES Misuse of the batteries can result in electrolyte leakage, rupturing, corrosion, etc. Bear in mind the following points when using batteries. · Remove the batteries from the remote control unit if the unit is not going to be used for a prolonged period (a month or more). · Do not use an old battery together with a new one. · Insert the batteries while ensuring that their ª and · poles are properly aligned with the corresponding markings on the remote control unit. · Batteries with the same shape may have different voltages. Do not use different types of batteries together. · If electrolyte has leaked, thoroughly wipe the inside of the battery compartment, and then insert new batteries. · When batteries which are no longer required are to be discarded, follow the directions (regulations) laid down by the local authorities in the area concerned for their disposal. OPERATABLE RANGE OF REMOTE CONTROLLER Operate the unit with the remote controller within the range of the illustration below. INFORMATION FOR USERS ON COLLECTION AND DISPOSAL OF OLD EQUIPMENT AND USED BATTERIES 1. Remove the battery cover. Approx. 5m Remote controller 2. Insert the batteries with correct +/­ orientation. Caution · Do not allow direct sunlight, an inverter fluorescent light or other strong source of light to shine onto the players infrared receptor window. Otherwise, the operation of the remote controller may be disabled. · Bear in mind that operating the remote controller may cause other devices operated by infrared rays to be operated by mistake. · The remote controller cannot be operated if the space between the controller and the players infrared receptor window is obstructed. · Do not place any objects on top of the remote controller. Doing so may cause one or more buttons to be held down which will cause the batteries to run down. 3. Close the battery cover until it clicks shut. 3 OTHERS TROUBLESHOOTING REMOTE CONTROLLER OPERATION ADVANCED CONNECTION When discarding the unit, comply with local rules or regulations. Batteries should never be thrown away or incinerated but disposed of in accordance with the local regulations concerning battery disposal. BASIC OPERATION BASIC CONNECTIONS NAMES AND FUNCTIONS BEFORE USE ENGLISH NAMES AND FUNCTIONS FRONT PANEL o BALANCE CONTROL Turn the knob to correct an unbalanced program source such as stereo broadcast or to vary the output level of the left or right channel. Note that, if the BALANCE control is turned fully in one direction, the sound will not be heard from the speaker on the other side. NAMES AND FUNCTIONS BASIC CONNECTIONS BASIC OPERATION ADVANCED CONNECTION REMOTE CONTROLLER OPERATION TROUBLESHOOTING OTHERS !0 LOUDNESS button and indicator This button turns LOUDNESS ON and OFF. When LOUDNESS is ON, the center of the button is lit. [. . . ] · To set the remote control back to AMP1, hold down both the AMP button z and 1 number button x on the remote control for at least five seconds. 2. 3. 4. 12 ENGLISH SPECIFICATIONS RMS Power output (20 Hz ­ 20 kHz simultaneous drive of both channels) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 45 W x 2 (8 load) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 60 W x 2 (4 load) Headphone rated output (When speaker rated output set to 8 load) . . . . . . . . . . . . . . . . . [. . . ]