User manual MARANTZ RC-5000I

[. . . ] RC5000i User Guide Automating Your Home Theater With The Marantz RC5000i Automating Your Home Theater With The Marantz RC5000i RC5000i Remote Control User Guide The information in this manual is copyright-protected. No part of this manual may be copied or reproduced in any form without prior written consent from Marantz America, Inc. CORPORATION SHALL NOT BE LIABLE FOR OMISSIONS OR FOR TECHNICAL OR EDITORIAL ERRORS CONTAINED IN THIS MANUAL. SHALL NOT BE HELD LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING FROM THE SUPPLYING OR USE OF THIS INFORMATION. [. . . ] Simply putting in lots of delays will make the macro work, but may make the macro unnecessarily long. Try moving commands, so that a TV command alternates with another component command before another TV command is issued. To move a command, simply select it and use the up and down arrows to reposition it within the macro window. When a delay is added to the macro, the default timing is . 5 seconds. If the macro works with a . 5 second delay, try a smaller delay to shorten the macro. When programming Channel macros, use . 1 second delays between different digits and . 5 second delays between identical digits. 13 Once you are happy with the macro, press the left hard button (now labeled Close). You will be prompted to Save Macro or Cancel. 14 Continue to program macros until you have recorded all that you plan. You are now a Home Theater Automator! 7. Programming Macros as a Device Action It is possible to program a macro to occur when you select a device (the macro will occur both when you press a home button and when you select the device from the pull down Device menu). To program: User Guide 1 Navigate to the Device side of the RC5000i. 26 Customizing Your RC5000i 2 Tap the mode button and press the LEARN mode button. 3 Tap the Device Tab and reveal the Device Menu. 4 While bracing the RC5000i with your right hand, press and hold the Backlight button with a left hand finger. 5 Press and hold the Left hard button with your left hand thumb. 6 While still bracing, pressing and holding everything, use a right hand finger to select the device from the Device Menu. 7 The EDIT window appears with the name of your Device at the top of the window. 8 Program your macro following steps 10 through 15 on the previous page. Note In use, you can select a device without issuing the macro by revealing the Device Menu, then pressing and holding the left hard key, then selecting the device. Otherwise, every time you select the device from home or select it from the device menu, the macro will be sent. 8. Protecting Your Work From Changes To hide the Mode menu To prevent accidental changes to the RC5000i interface and commands once you've finished customizing, you can hide the Mode menu. 2 Touch and hold the RC5000i icon for a few seconds. 3 Scroll down to the second setup panel. The Mode button is no longer visible. 27 User Guide Reference 1. Programming Buttons You program the RC commands (RC for Remote Control) by transmitting infrared signals from your existing remote controls to the RC5000i's learning eye. [. . . ] The RC5000i is calibrated when it leaves the factory, so normally you do not have to calibrate it yourself. It is possible that the RC5000i displays a message to calibrate the touchscreen. If this message appears do the following. You will see the instruction "Touch TOP LEFT corner. " 1 Tap as close as possible the upper left corner using a blunt tip of a pencil. [. . . ]