User manual MARANTZ RC9200

[. . . ] User Guide To The RC9200/RC5200 Touch Screen Remote Controls Automating Your Home Theater With Marantz Automating Your Home Theater With The Marantz RC9200/5200 RC9200/5200 Remote Control User Guide The information in this manual is copyright-protected. No part of this manual may be copied or reproduced in any form without prior written consent from Marantz Europe B. V. CORPORATION SHALL NOT BE LIABLE FOR OMISSIONS OR FOR TECHNICAL OR EDITORIAL ERRORS CONTAINED IN THIS MANUAL. SHALL NOT BE HELD LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING FROM THE SUPPLYING OR USE OF THIS INFORMATION. [. . . ] 5 Press and hold the Left hard button with your left hand thumb. 6 While still bracing, pressing and holding everything, use a right hand finger to select the device from the Device Menu. 7 The EDIT window appears with the name of your Device at the top of the window. 8 Program your macro following steps 10 through 15 on the previous page. Note In use, you can select a device without issuing the macro by revealing the Device Menu, then pressing and holding the left hard key labeled NO IR, then selecting the device. Otherwise, every time you select the device from home or select it from the device menu, the macro will be sent. User Guide 27 Reference 1. Programming Buttons You program the RC commands (RC for Remote Control) by transmitting infrared signals from your existing remote controls to the RC9200/5200's learning eye. To do this, place the RC9200/5200 and the device's remote control on a flat surface, 1 to 100cm (1/2 to 36 inches) apart. With each new remote control, you have to find the correct learning distance. It is best to be systematic and teach all of the buttons from one remote control before proceeding to the next. Start with the controls close together; if you receive a FAIL, move them farther apart in one inch increments. Although rare, some component remotes require a very large distance between the sending LED and the RC9200/5200's learning eye. Test the first command from any new remote control to find the correct learning distance. Once you have found the correct learning distance, do not change it for any other button on that particular remote control. Most commands learn correctly when you press and hold them until the OK indicator appears. However, sometimes the RC9200/5200 will say OK, yet the command will not operate the component properly. If this occurs, try re-teaching the command with a brief tap. After a short delay the OK indicator will appear. If this improves operation, continue to use the Tap technique for all other buttons on the remote. The only buttons that you MUST use the press and hold technique for are buttons that you will press and hold when you are operating the component (i. e. volume, scan, etc. ). User Guide 28 1 to 100 cm apart (1/2 to 36 inches) Reference The following buttons can be programmed: control panel buttons, Device menu items and Direct Access buttons. You cannot program Home menu buttons directly. You have to program them via the Device menu (see page 30). [. . . ] The RC9200/5200 is calibrated when it leaves the factory, so normally you do not have to calibrate it yourself. It is possible that the RC9200/5200 displays a message to calibrate the touchscreen. If this message appears do the following. You will see the instruction "Touch TOP LEFT corner. " 1 Tap as close as possible the upper left corner using a blunt tip of a pencil. [. . . ]