User manual MARANTZ SA-11S1

[. . . ] Model SA-11S1 User Guide Super Audio CD Player CLASS 1 LASER PRODUCT LUOKAN 1 LASERLAITE KLASS 1 LASERAPPARAT CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK) NO USER-SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. WARNING TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT. ATTENTION: POUR ÉVITER LES CHOCS ÉLECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPON-DANTE DE LA PRISE ET POUSSER JUSQU'AU FOND. LASER SAFETY This unit employs a laser. Only a qualified service person should remove the cover or attempt to service this device, due to possible eye injury. CAUTION : USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURE OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE. IMPORTANT SAFETY INSTRUCTIONS READ BEFORE OPERATING EQUIPMENT This product was designed and manufactured to meet strict quality and safety standards. There are, however, some installation and operation precautions which you should be particularly aware of. [. . . ] Connect the audio cable q to this unit's front speaker outputs and the stereo inputs on your amplifier, receiver or stereo system. Connect the optical cable w, coaxial cable e to the digital input on your AV amplifier, D/A converter, CD-R, etc. . * Signal will be output from the digital audio out jacks (OPT. /COAX. ) only when an Audio CD disc is played. No signal is output when playing a Super Audio CD. OPERATION * In this instruction manual, some operations can only be performed with the remote control. For operations that can be performed with buttons both on the main unit and on the remote control, the button names are shown in the mark. And for operations that can only be performed with buttons on the remote control, the button names are shown in the mark. ENGLISH CONNECTING THE POWER SUPPLY 1 Plug the power cable into AC IN jack on the back panel. NORMAL PLAYBACK 7 Super Audio CD player playback OPEN/ CLOSE SUPER AUDIO CD PLAYER SA-11S1 PLAY DISPLAY OFF STOP SOUND MODE POWER ON/OFF PAUSE A C IN q Press POWER switch to turn on. LCD 2 Turn on the power switch of the audio unit (amplifier, etc. ) 3 that is connected with this unit. Set the selector on the connected unit to this unit. The display cycles from TOC Reading No Disc (when no disc is loaded) Super Audio CD (when the start sound mode setting is Super Audio CD). w Press the OPEN/CLOSE button The disc tray comes out. Place the disc with label side up on the tray. To play a single (8cm) CD, place the disc with the indentation at the center of the tray. e Press r Press OPEN/CLOSE PLAY button. button. Disc type is automatically detected and playback is started. Track number and track elapsed time(minute, second) appear on the display. * For Super Audio CD/CD hybrid-layer discs (See page 3), the layer that is set in the start sound mode (See page 13) is played. To change the layer, use the SOUND MODE button. (See page 13) (Exp. :Track 6, Elapsed time 2 min 8 sec) Number of current track Minutes Seconds Remaining track numbers Playback automatically stops at the end of the final track. 12 OPERATION To start playback form the first track Press PLAY button. q Press SOUND MODE button in stop mode (not playing). The currently selected layer or area is shown on the LCD. (CD or Super Audio CD) If SOUND MODE button is pressed again, a playable layer or area will be shown, and the layer or area will be switched to new one. * When layer or area is switched, TOC will be read again. * The sound mode cannot be changed for Audio CDs and discs with only a Super Audio CD area. * The sound mode on hybrid layer discs will be changed in the following order. Super Audio CD stereo area CD layer Super Audio CD stereo area * Sound mode can be selected while the tray is open. Select a desired layer or area and press PLAY button then the tray will close and playback will be started. To stop playback Press STOP button. To eject disc Press OPEN/CLOSE button to open the disc tray and take the disc off. Press the button again to close the tray. Disc tray must be closed when the unit is not be used. To pause playback PAUSE button. [. . . ] Are the batteries in the remote control unit exhausted?Is there another strong light (from a window, etc. ) striking the Super Audio CD player's remote sensor? · · 22 SPECIFICATIONS Super Audio CD Audio Characteristics Analog output Channels Frequency range Frequency characteristics Dynamic range THD (1kHz) wow & flutter Output level Unbalanced Balanced Digital output output level (cinch JACK) output level (optical) Optical Readout System Laser Wave length Signal format Sampling frequency Audio CD 2channels 2Hz -- 100kHz 2Hz -- 50kHz (-3dB) 114dB (Filter 3) 0. 0009% (Filter 3) Precision of quartz 2. 5V RMS stereo (Filter 3) 5V RMS stereo (Filter 3) -- -- 2channels 2Hz -- 20kHz 2Hz -- 20kHz 100dB (Filter 3) 0. 0020% (Filter 3) Precision of quartz 2. 5V RMS stereo (Filter 3) 5V RMS stereo (Filter 3) 0. 5Vp-p (75) -19dBm AlGaAs 650nm 1-bit DSD 2. 8224MHz AlGaAs 780nm 16-bit linear PCM 44. 1kHz Power Supply U Version . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . AC 120V 60Hz Power Consumption . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Dimensions (Width × Height × Depth) . . . . . . . . . . . [. . . ]