User manual MARANTZ SA-15S2 UPDATED

[. . . ] 10 0:47:10 PM CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK) NO USER-SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product. Only a qualified service person should remove the cover or attempt to service this device, due to possible eye injury. cAUTION : USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURE OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE. [. . . ] €¢ After connecting, press the DIGITAL OUT button on the remote control while the CD is stopped and set the digital output for the audio CD signal from the DIGITAL AUDIO OUT terminal to ON. Switch the digital output ON and OFF using the button on the remote control. When digital output is switched OFF, “D OFF” lights up on the LDC display. To enjoy better sound quality, switch digital output to OFF when digital output is not in use. Indd 14 NAMES AND FUNCTIONS BASIC CONNECTIONS BASIC OPERATION ADVANCED CONNECTIONS ADVANCED CONNECTIONS APPLICATION OPERATION TROUBLESHOOTING OTHERS Caution: Signals are sent from the Digital Audio Output (Optical and Coaxial) terminals only when playing back audio CDs or the CD layer of Super Audio CDs. There are no signals when other media are being played back. 7 Connecting the optical output connector 7 Connecting the coaxial output connector Use an optical digital connecting cable available on the market. Insert the plug firmly in until it clicks into place. Do not bend or bundle the optical digital connecting cable. Use a coaxial digital connecting cable available on the market. 10 0:47:52 PM ENGLISH CONNECTING THE DIGITAL AUDIO INPUT TERMINAL When connected to devices equipped with digital outputs, such as CD transports or MD recorders, the unit can be used as a D/A converter. REMOTE CONTROL CONNECTION Connecting this player to additional Marantz audio equipment using the supplied remote control cable enables remote control of the connected equipment as a single audio system. €¢ When connecting equipment incorporating a remote sensor, connect the “remote control out” connector of the equipment to the “remote control in” jack of the CD player. When doing this, set this player’s switch to “EXTERNAL. € This will stop its remote control IR receiver from operating and the player can now be controlled via the remote control IR receiver of the attached equipment. Note: This unit can input linear PCM signals with sampling frequencies of 32kHz, 44. Please do not input signals other than linear PCM signals (such as CD-ROM, Dolby Digital, DTS, or AAC signals). Signals other than linear PCM may generate noise and damage the speakers. Indd 16 NAMES AND FUNCTIONS BASIC CONNECTIONS BASIC OPERATION ADVANCED CONNECTIONS ADVANCED CONNECTIONS APPLICATION OPERATION TROUBLESHOOTING OTHERS TIMER PLAY This unit can perform timer play by cooperating with your audio timer. Connect this unit’s power cord to the audio timer’s power socket and the timer’s power cord to power outlet. €¢ For connection to audio timer and it’s operation, please refer to the instruction manual of your audio timer. Keep pressing the POWER Switch for about a second to turn on the system. [. . . ] * Do not use discs which come in special shapes. Do not attempt to play heart-shaped or octagonal discs or discs with any other special shapes. You may find that you cannot remove them or that some other kind of malfunctioning may occur in the player. * Use discs which satisfy the CD standards such as ” or “ ” mark on their those with the “CD logo”, “ disc label surfaces. [. . . ]