User manual MARMITEK CONNECT 350

[. . . ] Do not expose the components of your systems to extremely high temperatures or bright light sources. In case of improper usage or if you have altered and repaired the product yourself, all guarantees expire. Marmitek does not accept responsibility in the case of improper usage of the product or when the product is used for purposes other than specified. Marmitek does not accept responsibility for additional damage other than covered by the legal product responsibility. [. . . ] Please read this manual first and follow the instructions so you can enjoy the possibilities of this product optimally. Can be placed out of sight and can still be operated with the remote control when using the external infrared receiver. Deep Color 12-bit (billions instead of millions colours, better reproduction of subtle differences in gradation and a higher contrast ratio) · Connect the HDMI cable to your screen (TV, monitor of projector) with the "HDMI output" of the Connect350. Connect the external infrared receiver to the "IR Extender" input of the Connect350 and mount it somewhere in sight of your remote control. For example up, under or at the side of your A/V centre. This way you can keep operating the Connect350, even when it is located in a closed cabinet. Connect the power adaptor to the power connector of the Connect350 and connect to the mains. remark 1: In most cases the Connect350 operates without power adaptor. Standard all HDMI cables are equipped with a 5V power pin, but unfortunately not all HDMI sources support this functionality. So it depends on your HDMI sources if connecting the power adaptor to the Connect350 is necessary. You can test this by simply disconnecting the power adaptor from the Connect350 and see if it is still functioning properly. Switching between the connected HDMI sources Automatically When one of the HDMI sources is switched on, the Connect350 will automatically switch to the correct input channel. With the selection button on the switcher With the Select button at the top of the panel you can manually switch between the various HDMI sources. With the remote control Point the remote control at the external infrared receiver of the Connect350 and press the number that corresponds with the desired HDMI source. No (or poor) image and sound If you experience poor or no image after connecting the HDMI switcher, try to recover the problem by connecting the devices one at the time to your screen (TV, monitor or projector). This way you can determine whether the problem lies with the HDMI sources, the HDMI cables, the HDMI switcher or the screen. HDMI devices which are not tested and certified by ATC (Authorized Test Centers) can cause image and sound problems. Check if the power adaptor of the Connect350 is connected and plugged into the mains. Do not use HDMI cables that are longer than specified in the technical data. Both the HDMI source and your screen have to support HDMI fully. [. . . ] Every remote control you are using at the moment. More information about these so called universal remote controls can be found at www. Hereby, Marmitek BV, declares that this Connect350 is in compliance with the essential requirements and other relevant provisions of the following Directives: DIRECTIVE 2004/108/EC OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL of 15 December 2004 on the approximation of the laws of the Member States relating to electromagnetic compatibility Directive 2006/95/EC of the European Parliament and of the Council of 12 December 2006 on the harmonisation of the laws of Member States relating to electrical equipment designed for use within certain voltage limits Directive 2002/95/EC of the European Parliament and of the Council of 27 January 2003 on the restriction of the use of certain hazardous substances in electrical and electronic equipment Hiermit erklärt Marmitek BV die Übereinstimmung des Gerätes Connect350 den grundlegenden Anforderungen und den anderen relevanten Festlegungen der Richtliniën: RICHTLINIE 2004/108/EG DES EUROPÄISCHEN PARLAMENTS UND DES RATES vom 15. Copyright and all other proprietary rights in the content (including but not limited to model numbers, software, audio, video, text and photographs) rests with Marmitek B. [. . . ]