User manual MARMITEK DOORGUARD 300

[. . . ] Do not expose the components of your systems to extremely high temperatures or bright light sources. In case of improper usage or if you have altered and repaired the product yourself, all guarantees expire. Marmitek does not accept responsibility in the case of improper usage of the product or when the product is used for purposes other than specified. Marmitek does not accept responsibility for additional damage other than covered by the legal product responsibility. [. . . ] Guide the cable to the spot where the monitor is to be mounted (Beware: there should be a power socket in the area). Mount the wall plate onto the wall using the four supplied screws. Mounting the monitor onto the wall (figure 7). Take the monitor and attach the connector(s) of the cable(s) in the right connectors (see figure 5). Connect the power adapter with the backside of the monitor (Figure 5). Now place the monitor against the wall plate and move it up and down against the plate such that it snap-locks onto the plate. Fasten it onto the side, using the additionally supplied screw (M3). Your DoorGuard300TM has now been installed successfully and is ready to use. You can always slide off the monitor by sliding it upwards, after you have removed the fastening screw. As soon as a visitor rings the doorbell by pressing on the doorbell button, the image will appear instantly on the monitor in the house. This way you can see who is at the door before you decide to open it (or pretend you're not at home). To speak to the visitor, you simply press the monitor button (13). If you have also installed an electric door opener, you can open the door by pressing on the door-open button (15). In case you have installed multiple monitors in the house (maximum 3 extra), then you can talk among each other using the intercom button (14). - You need an electric door opener with its own power supply. the door-open-contact of the monitor is a potential-free normally-open (NO) contact. - The maximum load for this contact is: DC24V/1A or AC24V/1A. - You need to connect the door opener onto the L+ en L- connectors of the monitor. Connecting multiple monitors - To be able to see who is at the door from several places (max. Upon that, you now have an intercom system (figure 9). [. . . ] For more detailed information about the disposal of your old equipment, please contact your local authorities, waste disposal service, or the shop where you purchased the product. Placez maintenant le moniteur contre le support mural et bougez-le (de haut en bas) de telle façon que le moniteur se glisse par-dessus le support mural et se fixe avec un clic. Hereby, Marmitek BV, declares that this DoorGuard300 is in compliance with the essential requirements and other relevant provisions of the following Directives: Council Directive 89/336/EEC of 3 May 1989 on the approximation of the laws of the Member States relating to electromagnetic compatibility Council Directive 73/23/EEC of 19 February 1973 on the harmonization of the laws of Member States relating to electrical equipment designed for use within certain voltage limits Hiermit erklärt Marmitek BV die Übereinstimmung des Gerätes DoorGuard300 den grundlegenden Anforderungen und den anderen relevanten Festlegungen der Richtliniën: Richtlinie 89/336/EWG des Rates vom 3. Copyright and all other proprietary rights in the content (including but not limited to model numbers, software, audio, video, text and photographs) rests with Marmitek B. [. . . ]