User manual MARMITEK INVISIBLE CONTROL 4

[. . . ] Check the polarity (+/-) of the batteries when inserting them in the product. Wrong positioning can cause an explosion. In case of improper usage or if you have opened, altered and repaired the product yourself, all guarantees expire. Marmitek does not accept responsibility in the case of improper usage of the product or when the product is used for purposes other than specified. [. . . ] Connect the wire with the two IR LEDs (the IR extender) to the back side of the Invisible Control 4TM. It doesn't matter whether you use the first or the second connection. Place the Invisible Control 4TM within sight and within reach of your remote control (max. Lead the wire with the IR LEDs (the IR extender) to the A/V equipment in such a way that the IR LEDs (transmitters) are on the front of your equipment (e. Use this to stick them onto the IR sensor of your equipment. This should be done very carefully and precisely. Test the position of the IR LEDs first, before you stick them onto the sensor. ATTENTION: If you are only using one appliance, then you do not need to use the second IR LED. The Invisible Control 4TM receives the signal from your remote control and transfers it to an electrical signal, which is passed on to the IR LEDs. This means all signals from your remote control are passed on to your equipment. The Invisible Control 4TM can be connected to the mains or can work using just a battery. If you are inserting a battery, the Invisible Control 4TM will automatically switch to stand-by mode after 4 hours, to conserve energy. You can activate the Invisible Control 4TM by pressing a button on your remote control within 50 cm of the receiver. A red light will flash to confirm the receiver is ready for use. After reactivation, the Invisible Control 4TM can receive all signals from the remote control within a distance of 4 to 8 m, under an angle of 30°. The Invisible Control 4TM will switch to stand-by mode when it has not been used for 4 hours. If you have connected the Invisible Control 4TM to the mains, it will remain switched on. You do not need to activate the Invisible Control 4TM with your remote control first. In a few cases, the Receiver may be disrupted by interference and cannot, therefore, pick up the signals it receives. If this is the case the red light will be continuously illuminated than the Receiver must be relocated. [. . . ] It is your responsibility to dispose of this and other electric and electronic equipment via designated collection facilities appointed by the government or local authorities. Correct disposal and recycling will help prevent potential negative consequences to the environment and human health. For more detailed information about the disposal of your old equipment, please contact your local authorities, waste disposal service, or the shop where you purchased the product. Algunas ventanillas IR de los set-top box o de los box sattelite son muy sensibles y fácilmente a sobrecargar. [. . . ]