User manual MARTIN AUDIO F-1 DATASHEET

[. . . ] 16 Coffee and espresso prepared from coffee beans . 16 Coffee and espresso prepared from ground coffee . 24 Coffee jug (dispensing several servings, one directly after another) . 28 Lighting: Setting the switch-off time. [. . . ] As soon as the component (which you have checked) is being dispensed, the display will read "Program the amount". ^ Once the cup is full to your liking with that component and "Save" appears in the display, tap OK to save the amount. ^ Repeat this process for the other components you have chosen for this type of coffee. Each time the drink is prepared it will contain the programmed amount of coffee, milk, etc. ^ Use < or > to reach the option you wish to program to a certain serving size. ^ Tap OK to place a check mark next to the desired component to show that you would like to program this component. ^ Repeat this process until all components you wish to program the serving size for are marked with a check. ^ Use < or > to select "Start", confirm with OK. 35 Setting the serving sizes Setting the serving size for hot water ^ Place the desired cup under the hot water dispenser. ^ Tap - until the display reads "Prog. ^ Tap - again once the cup is filled as desired and "Save" appears in the display. Each time the hot water is prepared the programmed amount will be dispensed. Setting serving sizes via "Settings" ^ Select "Settings F", confirm with OK. Settings Prog. the amount Amount of coffee ^ Tap < or > until "Prog. ^ Use < or > to select the user profile you wish to delete, confirm with OK. A check mark appears after the user profile, and it will be erased shortly. Revert The appliance can be set so that it automatically reverts to the standard user profile or continues to use the most recently selected user profile set. ^ Use < or > to select "Revert". You can now choose between: Manually The appliance retains the selected user profile until another profile is selected. ^ Use < or > to select "Manually", confirm with OK. After dispensing After each drink prepared, the appliance automatically reverts back to the standard user profile. ^ Use < or > to select "After each use", confirm with OK. When switched on Each time the appliance is turned on, the standard user profile will automatically be selected, no matter which user profile was set before it was last turned off. ^ Use < or > to select "When switched on", confirm with OK. 39 Cleaning and care Overview Frequency What needs to be done? Every time milk is prepared, if there Rinse the milk pipework is more than one hour between uses Rinse the system (intake lines) Clean the milk lines (with cleaning powder) Every day (at least at the end of the day, before you switch off the appliance) Clean the stainless steel milk container and lid Clean the main dispenser Clean the water tank Clean the waste unit Clean the drip tray and no spill grid Clean the bean container Clean the main dispenser connector Once a week (more often if there is a heavy soiling) Clean the interior Clean the inside door tray Clean the brew unit Clean the front of the appliance (especially right after descaling) Once a month Approx. every 200 portions Depending on the water hardness When necessary Lubricate the cap on the main spout connection Clean the brew unit (use the cleaning tablets) Descale the appliance Clean clogged milk pipework 40 Cleaning and care Rinsing the system Allow the coffee system to cool before cleaning. Do not clean the unit with a steam cleaner. [. . . ] Installation, repairs and other work by unqualified persons could be dangerous. Verify that the voltage, load and circuit rating information found on the data plate match the household electrical supply before installing the coffee system. Do not connect the appliance to a power inverter or directly to power produced outside of the normal electrical grid (i. e. Direct connection to such power sources can cause power surges and tripped breakers when the appliance is turned on, and could damage the appliance. [. . . ]