User manual MARTIN AUDIO MX5 V2

[. . . ] 41 3 IMPORTANT SAFETY INSTRUCTIONS Read these Operating Instructions carefully before installing or using the Ventilation System. This appliance is intended for residential use only. Use the appliance only for its intended purpose. The manufacturer cannot be held responsible for damages caused by improper use of the hood. This appliance complies with current safety requirements. [. . . ] Avoid: ­ cleaning agents containing soda, acids or chlorides, ­ abrasive cleaning agents e. g. powder or cream cleansers, ­ abrasive sponges, e. g. pot scourers or sponges which have been previously used with abrasive cleaning agents. These will damage the surface. 16 Cleaning and Care Grease filters The reusable metal grease filters remove solid particles from the vented kitchen air (grease, dust, etc). Depending on the detergent, cleaning the grease filters in a dishwasher may cause permanent discoloration of the filter surface. Performance of the filter will not be affected by this discoloration. ^ After cleaning, the filters can be placed on a towel to air dry. ^ While the filters are removed, clean any dirt or grease from the filter casing to prevent the risk of fire. When putting the grease filters back make sure that the locking clips are visible facing down towards the cooking surface. If a filter is incorrectly installed, insert a small screwdriver into the slit along its edge to disengage it from the casing. The grease filters should be cleaned every 3 - 4 weeks or whenever the grease filter indicator lights. A dirty filter is a fire hazard. ^ To remove the grease filters press the locking clips in towards the middle of the filter. Please contact your local recycling authority about the possibility of recycling these materials. Before discarding an old hood, unplug it from the outlet and cut off its power cord to prevent hazards. 23 Installation accessories 24 Installation accessories a 2 recirculation vents (recirculation mode only) b 2 protective shields prevent scratches to the chimney during installation. c 1 protective shield prevents scratches from the canopy during installation. d 1 diverter (recirculation mode only) e 1 flex hose for connecting the diverter to the exhaust connection. f 2 hose clips for securing the ducting. g 1 reducing collar for use with 5" (125 mm) exhaust ducting. h 1 non-return flap for vented air extraction only. i Upper retaining plate B secures the chimney extension. j Middle retaining plate C for additional stability of the chimney. k Lower retaining plate A secures the canopy and motor assembly. CAUTION: During the installation process please be careful of sharp edges that can cause harm. [. . . ] ^ Remove the protective foil from the canopy. ^ Pull the chimney apart slightly and slide it over the chimney extension. Do this carefully to prevent scatching the two pieces. ^ Slide the chimney down aligning its lower screw holes with those on the side of retaining plate A. If the chimney is not tall enough an optional chimney extension can be ordered. [. . . ]