User manual MARTIN AUDIO WT2 SCHEMATICS

[. . . ] Unpacking Thank you for purchasing a Martin Audio ceiling loudspeaker system. Every Martin Audio product is built to the highest standard and thoroughly inspected before it leaves the factory. After unpacking, examine the product carefully. [. . . ] After unpacking, examine the product carefully. Inform your dealer if transit damage is found. We suggest that you retain the original packaging so that the system can be repacked at a future date if necessary. Martin Audio and its distributors cannot accept responsibility for product damaged through the use of non-approved packaging. Compliance These products comply with UL2043 Fire Tests for Heat & Visible Smoke Release for Discrete Products and their Accessories Installed in Air Handling Spaces. These products conform to: EMC Directive 89/336/EEC Low Voltage Directive 73/23/EEC Listed UL1480 General Signaling Speakers. SUITABLE FOR USE IN AIR HANDLING SPACES See page 3 for recommended ceiling hole sizes >> All material © 2007. Note swivel-tab positions before fully tightening It is permissible for one of the five C8. 1T swivel-tabs to coincide with a C-bracket gap in order to maintain driver orientation. All material © 2007. Subject to change without notice. Step 5 Screw the loudspeaker to the C-bracket by tightening the screws from the underside of the baffle. Tightening the swivel-tab screws Step 6 Connect your pre-installed amplifier cable to the ceiling loudspeaker. Amplifier power input is via a 4-pin rising clamp plug providing + and ­ inputs and + and ­ Loop Through connections at the top of the loudspeaker can. Input & Loop Through connector All material © 2007. Subject to change without notice. The input and loop connectors must be fireproofed using the steel cover and screws provided. This cover has a 0. 75" (19mm) knockout and a clamped cable entry. Ceiling loudspeaker rear can ­ fireproof steel cover fitted Step 7 Fit a steel safety wire between its rear can safety tag and a suitable overhead supporting structure to provide backup support in the event of ceiling damage. Safety tag location All material © 2007. Subject to change without notice. Step 8 Push the grille into position ensuring that the grille is properly located in the baffle slots. Locate grille tags into slots Your Martin Audio ceiling loudspeaker is now ready for use. Warranty Martin Audio ceiling loudspeaker products are warranted against manufacturing defects in materials or craftsmanship over a period of 5 years from the date of original purchase. During the warranty period Martin Audio will, at its discretion, either repair or replace products which prove to be defective provided that the product is returned in its original packaging, shipping prepaid, to an authorised Martin Audio service agent or distributor. [. . . ] Subject to change without notice. Step 8 Push the grille into position ensuring that the grille is properly located in the baffle slots. Locate grille tags into slots Your Martin Audio ceiling loudspeaker is now ready for use. Warranty Martin Audio ceiling loudspeaker products are warranted against manufacturing defects in materials or craftsmanship over a period of 5 years from the date of original purchase. During the warranty period Martin Audio will, at its discretion, either repair or replace products which prove to be defective provided that the product is returned in its original packaging, shipping prepaid, to an authorised Martin Audio service agent or distributor. cannot be held responsible for defects caused by unauthorised modifications, improper use, negligence, exposure to inclement weather conditions, act of God or accident, or any use of this product that is not in accordance with the instructions provided by Martin Audio. [. . . ]