User manual MARTIN MAC 700 WASH

[. . . ] MAC 700 Wash user manual Dimensions All measurements are expressed in millimeters 285 120° 120° 675 365 12. 5° 66° 12. 5 xx° xx° 66 656 515 390 143 Min. c/c 530 450 270° 270° 565 © 2006 Martin Professional A/S, Denmark. No part of this manual may be reproduced, in any form or by any means, without permission in writing from Martin Professional A/S, Denmark. This product is for professional use only. [. . . ] Tilt calibration is most useful when multiple fixtures are arranged horizontally. To calibrate, set zoom and pan position for easy side-by-side comparison and set each fixture to the same tilt DMX value. Select one fixture to be the reference fixture. On the other fixtures, select and press [Enter]. Adjust the offset as necessary to align the beam with the reference beam. To calibrate the dimmer, select and press [Enter]. Set the offset to zero and then increase it until a clearly defined M shape with minimal light spill is projected onto the paper. Press [Enter] to save the setting and remove the paper. To calibrate color mixing flags (cyan, magenta, yellow and CTC), project white beams with no dimming and position them for easy comparison. On each fixture, including the reference, select and press [Enter]. Adjust the offsets on the other fixtures to match the reference color. Repeat for (magenta), (yellow) and (CTC). FANS The cooling fans can be set to either full speed or thermostatically regulated operation via . In lower ambient temperature environments, regulated operation is recommended if reduced noise levels are desired. is maximized if fans are set to full speed. SOFTWARE UPLOAD The upload mode command () prepares the fixture for a software update. This command is not normally necessary, as upload mode is engaged automatically by the uploader. Control panel 15 Effects This section describes the effects in the MAC 700 Wash with reference to the DMX channels used to control them. See page 23 for the complete DMX protocol. The MAC 700 Wash has two DMX operating modes, 16-bit basic and 16-bit extended. The 16-bit basic mode uses 16 DMX channels, and 16-bit extended mode uses 23 channels. Extended mode provides all features of the basic mode plus fine control of the dimmer, cyan, magenta, yellow, CTC, color wheel and zoom. Where fine control is available, the main control channel sets the first 8 bits (the most significant byte or MSB), and the fine channels set the second 8 bits (the least significant byte or LSB) of the 16-bit control byte. In other words, the fine channel works within the position set by the coarse channel. Lamp power LAMP-ON The lamp-on command on channel 1 strikes the lamp if it is off. If the lamp is on, this command has no effect. [. . . ] . IP 20 INSTALLATION Mounting points . 2 pairs of 1/4-turn locks Minimum distance from illuminated surface. 1. 2 m (48 in. ) Minimum distance from combustible materials . 3 m integral cable without power plug DMX data in/out . [. . . ]