Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual MARYNEN CMA60R. We hope that this MARYNEN CMA60R user guide will be useful to you.
Lastmanuals help download the user guide MARYNEN CMA60R.
Detailed instructions for use are in the User's Guide.
[. . . ] The air is vented outdoors by a duct which must be connected to the coupling ring S (See figure 3 "Installation"). choosing the exhausting pipe The coupling ring S has a diameter of 120mm. We suggest to use Ø 120 mm exhausting pipe. [. . . ] Therefore, never use an open flame under the hood. When frying foods, never leave the pan alone because the cooking oil could flare up. -- Please , keep to the provisions of official directives regarding the question of fume discharge. -- The manufacturers refuse to accept any responsibility for damage to the hood or its catching on fire because of failure to observe the above instructions. Put the template onto the wall (1) and drill two Ø12mm holes (2). Remove the metal filters (4), hang the hood on the hooks and adjust the position of the hood using the two screws on the bottom of the hooks (5). And from the inside of the hood mark two point (6). remove the hood and drill two Ø8mm holes on the marked points. Fit two Ø8mm wall dowels (7), Hang again the hood and fix the hood definitively with two screws 5X45 (8) from the inside of thehood. Fix the chimney support (10) with two screws 5 x 45 mm (11) and two wall dowels (9) on the wall close to the ceiling. Fit the connection ring S on the top of the hood with two screws Ø 3, 5 x 6, 5 mm (12S) then fit an axhausting pipe long enough to reach the outside (13S). Fit the chimney (15) and fix it on the chimney support with two screws 3, 0 x 9mm (16). The lower part of the chimney must be slided down and inserted on the housing on the upper part of the hood (17). Fit the two grids (18) on both sides of the chimney. Before performing any maintenance operation, disconnect the hood from the electricity. Remove the metal filter using the handles designed for this purpose by pulling them backwards and then downwards (Fig. [. . . ] E) Before calling for repair service because the hood fails to light up, make sure the bulbs are screwed in tightly. Before calling for Repair Service because the hood fails to light up, make sure the lamp is well-inserted. To clean the outside of the hood use a cloth moistened with denatured alcohol or neutral liquid detergents. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE MARYNEN CMA60R
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual MARYNEN CMA60R will begin.
