User manual MASTERCRAFT X-30 WAKEBOARD 2001

[. . . ] The hood must NEVER be used as a support surface unless specifically indicated. The premises where the appliance is installed must be sufficiently ventilated, when the kitchen hood is used together with other gas combustion devices or other fuels. The ducting system for this appliance must not be connected to any existing ventilation system which is being used for any other purpose such as discharging exhaust fumes from appliances burning gas or other fuels. The flaming of foods beneath the hood itself is severely prohibited. [. . . ] If the hood is supplied with carbon filter, then it must be removed. When there is no exhaust duct for venting outdoors, you can use a carbon filter. The air is depurated by the filter and put again in the surrounding. If the hood is not supplied with carbon filter, then it must be ordered and mounted. The filtered air is returned from atop the cabinet through a duct that passes through the cabinet itself. The diameter of the duct must be the same as that of flange H. The deflector J can be fixed to the outlet hole using the two screws provided. 4-5 Filter version Installation The minimum distance between the supporting surface for the cooking equipment on the hob and the lowest part of the range hood must be not less than 43cm from electric cookers and 65cm from gas or mixed cookers. If the instructions for installation for the gas hob specify a greater distance, this must be adhered to. The mains power supply must correspond to the rating indicated on the plate situated inside the hood. If provided with a plug connect the hood to a socket in compliance with current regulations and positioned in an accessible area, after Electrical connection 7 installation. If it not fitted with a plug (direct mains connection) or if the plug is not located in an accessible area, after installation, apply a double pole switch in accordance with standards which assures the complete disconnection of the mains under conditions relating to over-current category III, in accordance with installation instructions. Before re-connecting the hood circuit to the mains supply and checking the efficient function, always check that the mains cable is correctly assembled. Mounting Expansion wall plugs are provided to secure the hood to most types of walls/ceilings. Push the A knobs inwards toward each other (in the “Open” direction as indicated on the plastic knob itself). To remove the grates completely, use the B spring fasteners, which act as pins to hold the grate in place (Fig. Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at the connector and removing the connector fuse. Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket. Cleaning The cooker hood should be cleaned regularly (at least with the same frequency with which you carry out maintenance of the fat filters) internally and externally. Clean using the cloth dampened with neutral liquid detergent. WARNING: Failure to carry out the basic cleaning recommendations of the cooker hood and replacement of the filters may cause fire risks. Therefore, we recommend oserving these instructions. The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations. Description of the hood Grease filter Traps cooking grease particles. If situated inside the support grill, it may be one of the following types: Paper filter must be replaced once a month or if colouring appears on upper side, in such cases the colouring is evident through the grill openings. 8 Sponge filter should be washed with hot soapy water once a month and replaced every 5 to 6 washes. Metallic filter must be cleaned once a month, with non abrasive detergents, by hand or in dishwasher on low temperature and short cycle. When washed in a dishwasher, the grease filter may discolour slightly, but this does not affect its filtering capacity. [. . . ] Always replace burnt-out lamps, according to what is provided for your appliance, with olive-shaped max. 40 Watt (E 14) bulbs, or neon-lamp 14 Watt max. , or PL lamp 11 Watt (one PL lamp appliance) or PL 9 Watt (two PL lamp appliance). Close the light cover support or the back grease filter support grate. If the lights do not work, make sure that the lamps are fitted properly into their housings before you call for technical assistance. Charcoal filter (filter version only) It absorbs unpleasant odours caused by cooking. [. . . ]