User manual MATSONIC MS7023D

[. . . ] Important Information Copyright This publication, including all photographs, illustrations and software, is protected under international copyright laws, with all rights reserved. Neither this manual, nor any of the material contained herein, may be reproduced without the express written consent of the manufacturer. Disclaimer The information in this document is subject to change without notice. The manufacturer makes no representations or warranties with respect to the contents hereof and specifically disclaims any implied warranties of merchantability or fitness for any particular purpose. [. . . ] 7. Secure the metal bracket of the card in the empty slot in the system case with a screw. For some add-in cards, for example graphics adapters and network adapters, you have to install drivers and software before you can begin using the add-in card. PCI add-in card PCI slot Metal bracket Edge connector Note: If you have installed an AMR card, you should check the settings of jumpers JP4 (audio/modem enable/disable) and JP6 (select onboard codec or AMR codec). You should disable the onboard audio/modem to avoid conflicts with the AMR card. You can use the AMR codec chip (if it has one) or the onboard codec chip. 35 Add-in Card Options The mainboard has two features that can be used if you have installed either a fax/modem card or a network adapter card. WOL1: Wake on LAN If you have installed a network adapter (LAN adapter), you can use the cable provided with the card to plug into the WOL1 connector on the mainboard. When your system is in a power­saving mode, any traffic through the network automatically resume the system. You must enable this item using the Power Management page of the setup utility. See Chapter three for more information. WOL1 WOM1 WOM1: Wake on Modem If you have installed a fax/modem card, you can use the cable provided with the card to plug into the WOM1 connector on the mainboard. When your system is in a power­saving mode, any incoming calls to the modem automatically resume the system. You must enable this item using the Power Management page of the setup utility. See Chapter three for more information. 36 Install Options and Extension Brackets This mainboard has a number of special connectors that allow you to add optional features to your system. You can install any of the following items: Fax/modem card option Network adapter extension bracket Infrared port 24-bit digital audio extension bracket (SPDIF) Fax/modem Card You must install the fax/modem card in order to use the built-in fax/modem. J4 37 The fax/modem card is an optional item supplied with this mainboard. Locate the J4 fax/modem connector on the mainboard. Remove the expansion slot blanking plate from the system chassis that is adjacent to the fax/modem connector. Install the fax/modem card on to the J4 connector as shown below. The RJ11 Line and Telephone sockets on the bracket are positioned in the expansion slot with the removed blanking plate. Line and Tel RJ11 sockets Fax/modem card J4 fax/modem connector 38 Infrared Port This option can be purchased from third-party vendors. SIR1 1. 2. If you are installing an optional serial infrared port, connect the cable from the optional IR port to the SIR1 connector on the mainboard. After you have connected the cable, secure the optional IR port to the appropriate place on your system case. Note: An IR port may use some of the resources required by a fax/modem card. If you have more than one of these items installed, you may not be able to use them at the same time. You can use the Peripherals page of the setup utility to switch resources between an IR port and a second serial port. See Chapter 3 for more information. 39 Digital Audio Extension Bracket You can purchase an optional 24-bit digital audio extension bracket from a third-party vendor. [. . . ] To install the audio applications, log on to the W95-98 folder, and then log on to the APPS folder. Windows NT 4. 0 Installation Press the "Start" button. Move the highlight to "Settings" and select "Control Panel". Double click on the "Multimedia" icon. [. . . ]