User manual MAVIC WINTECH ULTIMATE

[. . . ] 3 Adjust the position of the speed sensor so the center of the magnet is aligned with one of the arrows on the sensor. The distance between the magnet and the sensor must be between 5 - 10 mm. IMPORTANT: At this point, your computer is not yet ready to function. You still need to set the necessary programs, and then perform the pairing operation of your device. [. . . ] When you have set the odometer, use the right button to validate. - Measure the distance (Ø) between these two points in millimeters. Hold down the right button for more than 4 seconds. the bike number flickers and the CIR display appears. If necessary, use the left button to modify the bike number (1, 2 or H), then validate with the right button. Enter the distance you have already measured (in millimeters), by modifying the flickering digit with the left button, then validate with the right. When you have set the circumference, validate with the right button. 4 Then use the left button to select the distance unit (Miles or Kilometers). - Make a mark on the tire and on the ground at the point of contact between the tire and the ground. Ground the place where the mark on the tire touches the ground. From any screen, press the right and left buttons simultaneously for 2 seconds to reset the following trip data to zero: - ATM - DST 14 - Average speed - Maximum speed - Average cadence - Maximum cadence - Intermediary stopwatches To start the next intermediary stopwatch (CR 2), just press the right button for another 2 seconds, and so on for the 9 possible intermediary stopwatches. Use the left button to select screen 3 (ATM). Press the left button for 2 seconds to display the data corresponding to the first intermediary stopwatch (CR 1) in loop display (2 seconds per screen): stopwatch time, distance covered and average speed. Briefly press the left button to switch to the next stopwatch. Press the left button for 2 seconds to quit consultation mode and return to normal display. In the course of a session you can use up to 9 intermediary stopwatches in order to evaluate your performance on specific hills or sections. Remember, the stopwatch only starts during a session i. When the computer already indicates a speed. From any screen in the course of a session you can press the right button for 2 seconds to make the CR symbol flicker. The first stopwatch (CR 1) starts when you release the right button. When you are using an intermediary stopwatch, the stopwatch time replaces the ATM data in screen 3. Use the left button to select screen 4 (ODO). [. . . ] CLAIMS UNDER WARRANTY - PROCEDURE Authorised retailers are at the users' disposal to manage any warranty claims. The authorised retailer must obtain the consent of Mavic® AfterSales Service (or its representative in the country concerned (1)) prior to returning a product under warranty. The entire product, accompanied by proof of the date of purchase (warranty card dated, signed and stamped by the authorised retailer or other proof of the date of purchase) shall be sent by the authorised retailer to Mavic® After-Sales Service (or its representative in the country concerned (1)), which will undertake the operation. The new or repaired product shall be returned to the authorized retailer. [. . . ]