User manual MAXTOR CHEETAH 18XL INSTALLATION

[. . . ] · Always use forced-air ventilation when operating the drive. · Use caution when troubleshooting a unit that has voltages present. · Do not disassemble the drive; doing so voids the warranty. · Return the entire drive for depot service if any part is defective. [. . . ] Motor start delay equal to the SCSI ID multiplied by 12 seconds. (default) J6 Reserved LR E EA A A A DS32 10 7. Format the drive The drive has been low level formatted at the factory. You do not need to perform another low level format on this drive unless you decide to perform certain diagnostics through the host adapter. If you do decide to perform a low level format, do not abort the format as this is likely to make the drive inoperable. A low level format, with verify turned on, will typically take up to one hour. Protect against power failure or other power interruptions during the format. Boot the system from a system floppy, CD, or from a previously installed hard disc drive if there is one. Formatting a drive erases all user data. Be sure that you understand this principle before formatting any hard disc drive. It is not necessary to format a drive that previously has been used to store data, unless your intention is to erase all user data. Seagate is not responsible for lost user data. Cheetah disc drives are designed to operate with a variety of operating systems. Please refer to your system or SCSI controller manual for information about formatting and setting up the drive. Some quick desktop system notes are provided below. Set the drive type in CMOS to "Zero, " "None, " or "No hard drive installed. " Use FDISK. EXE and FORMAT. EXE. Systems using Windows 98 or later can create one single partition (drive letter) on the drive. Use a third-party drive utility (most revisions of Apple's HD Setup utility only work with drives having special Apple firmware). Reserved 11 Remote LED Motor Start option 12 CATH Shipped with cover installed. Do not install jumpers on these four positions. J6 Drive Front J6 Jumper Disable motor start (default). The drive starts according to the Delay Motor Start option. The drive waits for the Start Unit command from the host before starting the spindle motor. [. . . ] Before calling, note your system configuration and drive model number (ST318404LW, ST318404LC, ST39204LW, or ST39204LC). Africa +31-20-316-7222 Poland 00 800-311 12 38 Australia +61-2-9725-3366 Spain 900-98 31 24 Austria 0 800-20 12 90 Sweden 0 207 90 073 Belgium 0 800-74 876 Switzerland 0 800-83 84 11 Denmark 80 88 12 66 Singapore +65-488-7584 France 0 800-90 90 52 Taiwan +886-2-2514-2237 Germany 0 800-182 6831 Turkey 00 800-31 92 91 40 Hong Kong 800-90-0474 United Kingdom 0 800-783 5177 Ireland 1 800-55 21 22 USA/Canada/ 1-800 SEAGATE or Italy 800-790695 Latin America +1-405-936-1234 Middle East +31-20-316-7222 Other European Netherlands 0 800-732-4283 countries +31-20-316-7222 Norway 800-113 91 Warranty. Contact your place of purchase or our web site (above). Before returning the drive, verify that it is defective. [. . . ]